Your cart is empty.
Your cart is empty.Application Procedures 1. The body of the vehicle must be clean and dry to achieve the best adhesion. Clean with 70% Isopropyl Alcohol. 2. The pressure sensitive adhesive on the molding must not be contaminated during the application. 3. The molding must be applied to achieve complete contact (bond) of the adhesive to the vehicle. (i.e. maximum wet-out) 4. Molding adhesion is best when applied at temperatures above 80 degrees Fahrenheit to 110 degrees Fahrenheit. 5. During cold weather, warm molding with a heat gun or heat lamp. Be careful not to damage the surface. 6. Cut molding with an anvil type cutter to proper length. 7. Allow 24 hours for molding to set.
$203.21
$ 84 .99 $84.99