Shopping Cart

Your cart is empty.

Your cart is empty.

3.5-Inch Cold Air Intake Kit with Heat Shield + Filter Compatible for Chevrolet Chevy Camaro LT/LS V6 2012-2015 (Black Tube & Red Filter)

Free shipping on orders over $29.99

$79.89

$ 36 .99 $36.99

In Stock

1.Style:Black Tube & Black Filter


About this item

  • 【Compatible with】Cold Air Intake Fit for Chevrolet Camaro V6 2012-2015 (3.6L V6 Engines Only)
  • 【The Air Intake Kit】Help your engine to draw in more cold air resulting in better throttle response and higher explosive horsepower output
  • 【The Heat Shield】Protect the filter from dirt and debris and to keep hot underhood air away from the element for a cooler intake air charge
  • 【Function】Designed to increasing 5-10% horsepower & 6-8% torque, improve your fuel efficiency and creating an attractive intake noise
  • 【Easy to Install】Easy to install and easy to fit with simple tools. No additional parts will be needed for installation after you purchase this kit


Fitment:

Compatible for Chevrolet Camaro LT/LS V6 2012-2015 (3.6L V6 Engines Only)


Package Includes:

Intake Tube

Air Filter

Heat Shield

Clamp

All accessories on the picture are included.


pablo
Reviewed in the United States on September 28, 2024
I only gave it 4 stars because the box didn't turn out the way I would have liked and it was difficult to install but in the end it worked. I like it and I can feel the difference in acceleration. They need to improve on the built the box shield because doesn’t fit I had to make some modifications thank you thumps up 👍
Anonymous
Reviewed in Canada on August 8, 2024
Just received today. Didn't come with any type of instructions at all. First time ever receiving something without instructions. Guess I'll figure it out
Chenar
Reviewed in the United States on August 12, 2024
I bought this for my car but it’s too short it’s not fit for my car 2015 Camaro I share photo you can see
Drew P.
Reviewed in the United States on January 28, 2024
Fit was alright but looks great.
Kari Kapavik
Reviewed in the United States on September 1, 2023
be prepared to drill a hole. . the made side holes dont line up. after putting in the top screw, the bottom hole was 1/2 inch off. also the map sensor and EGR vacume line are too close together.. should be about 15 degrees further away from each other.. also the main filter back wont fit inside the hole. no matter how hard you try, it wont fit. you cant trim the edge off the filter back, because that's what keeps the rubber on it with a clamp.. so your forced to break out the files or dremmel and open up the metal hole. after an hour or so, i was able to fit the filter main piece into the hole and it all lined up perfectly. if you try and shove the rubber through the hole and allow the housing to stay on the filter side, it wont line up with the intake manafold. so yea.. its not because i wasn't assemling it right.. its because the chineese workers didn't compensate for the lip on the filter backing. other than that, this thing works pretty good.. engine breaths a little better.. havent noticed much power boost, but didn't expect it to do so with stock exhaust.. but it will help when i swap out the stock exhaust for something better..
Customer
Reviewed in the United States on August 31, 2023
Rubber boot was dry rotted, cracked all over and split out within the first drive.
Recommended Products