Your cart is empty.
Your cart is empty. Feature:
This Cooling relay wiring kit takes all of the guess work out of installing a single or a dual fan setup
Perfect for the professional auto mechanic,the weekend mechanic and for all DIY'ers
It will make installing any Electric Fan(s) to your cooling system project that much easier
Description:
100% Brand New, Never been used
Material: Plastic and Metal
Voltage: 12V DC
165~185 degree electric fan thermostat relay switch kit, It is a 3/8" pipe thread
The kits includes everything you'll need to hook up to your fan
Comes on at 185º AND Turns off at 165º
The kits is set up to turn your electric fan on at 185 degrees and shut off at 165 degrees and will work with any 12 volt system
Please check the size measurement chart carefully before making a payment
Please allow 0.1-0.5cm difference due to manual measurement
Instruction is not included
Professional installation is highly recommended
Fitment:
Fits for 265 283 305 307 327 350 383 400 396 402 427 454 472 502 260 289 302 351W 347 352 360 390 406 427 428 429 460 351C 351M 400M 273 318 340 360 361 383 400 413 426W 440 455 330 326 Engines
About the Relay
Relay is an electrical control device that usually used in automatic control circuit
The relay in fact is an automatic switch which uses a smaller current to control a larger current
What's the Relay Used for
Compatible with almost all automobiles and devices equipped with a 12V DC power supply
Like starter kills, power door lock/actuator control, change a low current output to high current, add ignition/accessory outputs,control motors/other electronics
It is also suitable for automobile used for control, alarms, horn, headlight and more
About the Relay Pins
Pins 85 & 86 - are used to turn 'on' the relay. You need a positive (+) and negative (-) power source to turn on the relay
- Pin 85 - is usually negative (-)
- Pin 86 - is usually positive (+)
Pin 30 - is either a (+) or (-) source that feeds Pin 87 or Pin 87a
Pin 87 - when the relay is 'on': Pin 30 and Pin 87 are connected
Relay Kits Instructions:
RED + connect directly to battery
WHITE wire to ignition switch power source
BLACK goes to thermos switch
BLUE wire goes to the Fans
What's Note
The relay is rated for 30A, while the socket 14AWG wires are not big enough for the rated 30/40 amps
If you are intending to run 30 amps continuously, you could remove the spade contacts from the connector, carefully open the crimps securing the wire to the contact and recrimp/solder 10 gauge wires to it
Also, you can use 6.3 mm female connectors to connect directly to the relay pins. The relay should be good for 30 amps
$31.89
$ 13 .99 $13.99
$27.94
$ 12 .99 $12.99