Shopping Cart

Your cart is empty.

Your cart is empty.

3PCS DRV8871 DC Motor H-Bridge DC Drive Breakout Board 6.5V-45V 3.6A MaxH-Bridge Brushed DC Motor Driver Breakout Board PWM Control for Arduino

5.0 Write Review
Free shipping on orders over $29.99

$17.99

$ 7 .99 $7.99

In Stock

About this item

  • DRV8871 DC Motor Drive Module for Brushed DC Motor; The DRV8871 device has advanced currentregulation circuitry that does not use an analog voltage reference or external sense resistor. This novel solution uses a standard low-cost, low-power resistor to set the current threshold. The ability to limit current to a known level can significantly reduce the system power requirements and bulk capacitance needed to maintain stable voltage, especially for motor startup and stall conditions.
  • RV8871 H-Bridge Brushed DC Motor Driver Breakout Board For Arduino PWM Control 3.6A Max Internal Current Sense 6.5V To 45V
  • The DRV8871 device is a brushed-DC motor driver for printers, appliances, industrial equipment, and other small machines. Two logic inputs control the Hbridge driver, which consists of four N-channel MOSFETs that can control motors bidirectionally with up to 3.6-A peak current. The inputs can be pulsewidth modulated (PWM) to control motor speed, using a choice of current-decay modes. Setting both inputs low enters a low-power sleep mode.
  • Application:Printers; Appliances; Industrial Equipment; Other Mechatronic Applications;
  • 3.6A DC Motor H-bridge PWM Driver Module


Features:
H-Bridge Motor Drive Module
Drives One DC Motor, One Winding of a Stepper Motor, or Other Loads
Wide 6.5-V to 45-V Operating Voltage
565-m Ohm Typical RDS(on) (HS + LS)
3.6-A Peak Current Drive
PWM Control Interface
Current Regulation Without a Sense Resistor
Low-Power Sleep Mode
Small Package and Footprint
8-Pin HSOP With
Integrated Protection Features:
VM Undervoltage Lockout (UVLO)
Overcurrent Protection (OCP)
Thermal Shutdown (TSD)
Automatic Fault Recovery
Package included:
3 x DRV8871 DC Motor Drive Modules