Shopping Cart

Your cart is empty.

Your cart is empty.

539110411 Drive Belt for Husqvarna Zero Turn Models Z246 Z254 Z4824 Z5426 CZ3815 CZ4217 CZ42175 RZ4619 RZ4623 RZ5424 RZ5426 Garden Lawn Mower Tractor

5.0 Write Review
Free shipping on orders over $29.99

$18.99

$ 8 .99 $8.99

In Stock

About this item

  • This is a manufacturer replacement product. Part numbers include: 110411, 539110411
  • Dimensions: 57 Inch Length x 1/2 Inch Top Width, Package Includes: 1PCS x 539110411 V-Drive Belt
  • Replaces: Husqvarna 539110411
  • Compatible with Models including: Husqvarna Z246, Z254, Z4824, Z5426, CZ3815, CZ4217, CZ42175, RZ4619, RZ4623, RZ5424, RZ5426 Zero Turn Lawn Tractors and Garden Tractors
  • Description: This is a manufacturer's replacement product. Parts may differ in appearance but are functionally equivalent to the previous part. Belt Application: Transmission


Product Description

Timing for Belt Replacement

Wear or Cracks: Replace immediately if visible cracks, edge wear, or deformation of V-grooves (common in V-belts) appear on the belt surface.

Slippage or Power Loss: Replace if the belt slips due to looseness and tension adjustments fail to resolve the issue.

Noise or Vibration: Replace if abnormal noise or vibration occurs during operation, which may indicate aging or improper installation.

1500-1125 1

The surface of the belt is covered with a neatly woven rubber layer with a granular structure for enhanced adhesion

1500-1125 2

High-quality rubber is used to ensure the accuracy and appearance of the product

1500-1125 3

The drive belt core is reinforced to improve the tensile strength of the drive belt

1500-1125 4

One of the most important parts of keeping the machine in working order is to keep a close eye on the drive belt to ensure that the tension is correct

1464-600 1

General Replacement Steps (Applicable to Most Models)

Safety Preparation: Park the machine on flat ground, engage the parking brake, and disconnect the spark plug wire to prevent accidental ignition.

Secure wheels with blocks to prevent rolling.

Remove the Cover: Use a screwdriver or ratchet tool to remove the belt cover screws.

Release Tension: Disconnect the idler spring or adjust the tensioner pulley (e.g., rotate the idler with a ratchet tool) to release belt tension.

Document the Path: Sketch the belt routing diagram before removal to ensure correct reinstallation.

Install the New Belt: Route the new belt along the original path around all pulleys, ensuring alignment with the machine’s operating direction. Use a pry bar or lever tool (if required) to assist installation; avoid forcing the belt to prevent damage.

Adjust Tension: Adjust belt tension by repositioning the idler pulley or tightening the adjustment nut.

Reassemble: Tighten all bolts and reinstall the cover.

Test Run and Precautions

Start the machine and check for smooth belt operation without noise or vibration.

Regular Inspection: Inspect the belt every 50 operating hours or at the end of each season to prevent unexpected failures.

Precautions

Direction: Ensure the belt aligns with the machine’s operating direction; incorrect installation accelerates wear.

Pulley Cleanliness: Clean pulleys of oil or debris before installation to prevent slippage.

Avoid Forcing: Use specialized tools (e.g., pry bars) for disassembly; never pry directly on the belt to avoid structural damage.

Maintenance: During off-seasons, release tensioner pressure or store belts in dry conditions to extend lifespan.

Safety Warning: Wear protective gloves to avoid injury from springs or tools.