5PCS DC DRV8833CPWR Motor Drive Board 2 Channel 3-10V 1.5A H Bridge DC Gear Motor Driver Controller Small Volume Board for DIY Projects
$8.59
$8.59
$
3
.99
$3.99
- Size: 0.73*0.63"(18.5*16mm); Input voltage: 3 - 10V; Single H bridge output current: 1.5A, can drive 2 DC geared motors
- Built-in overcurrent protection, short circuit protection, undervoltage lockout and overtemperature protection. With low power sleep mode
- The DC DRV8833CPWR Motor Drive Module Board can work with PWM inputs either directly from an Arduino, Raspberry Pi, Jetson Nano, or a PCA9685 driver board
- For DIY projects like robots, RC vehicles, or motorized gadgets. It can drive DC motors up to 1.5A and 4-wire stepper motors. For better using, suggest to not go over 4V (1S LiPo) and run only 3V DC motors
- Instructions for use:ULT low level is sleep mode (need to disconnect the J2 short solder joint behind the module). OUT1, 0UT2 is a 1-way H-bridge, and the corresponding control is IN1, IN2. OUT3, 0UT4 is the second H-bridge, and the corresponding control is IN3, IN4. EEP is the protection output and is not used by default. VCC is a voltage input of 3 to 10V. GND is grounded
