Your cart is empty.
Your cart is empty. Nanovna-H4 - 4'' Portable Antenna Analyzer
AURSINC NanoVNA-H4 vector network analyzer is a Hugen Origin that provides perfect vector network measurement capabilities, tiny and handheld, stand-alone with 4-inch LCD display, with 1950mAh battery powered or USB powered. With latest HW 4.3 version, Nanovna-H4 is added a brand new panel plus added a new SD port for data storage(support up to 32GB memory card, not included in the package)
[Antenna Performance Measurement] The default firmware main function for NanoVNA-H4 vector network analyzer is used for antenna performance measurement. It has good RF performance for S-parameter measurements as previous models.The TX/RX method can measure the complete S11 and S21 parameters. If you need to obtain S12 and S22, you need to manually replace the transceiver port wiring
[NOTE] the Nanovna is only compatible with the low-speed and supports SPI mode SD cards for now. It is very efficient vector testing for ham radio operator, research electrical engineer and antenna builders
What are Included
1 x NanoVNA-H4 host (with 1950mAh battery)
1 x USB Type-C data cable
2 x 30mm SMA male to male RG174 RF cable
1 x SMA simple calibration kit (OPEN/LOAD/SHORT)
1 x SMA female to female connector
Filter Attenuator Frequency Test Board [Note] The test parameters of the 18 patterns of the test board are described as follows. Two steps must be performed before testing: Step 1. Connect the two 20CM SMA to IPEX adapter cables to the NanoVNA-F machine. Step 2. Recalibrate the machine using the 13 Short, 14 Open, 15 Load, and 16 Thru circuits on the test board, and save the parameters to SAVE 0
[Package Included]
1x PCB RF tester board
2 x 20cm adapter cables
$1,804.75
$ 99 .00 $99.00