Glen M.
Reviewed in the United States on February 15, 2022
Everything fit like a glove. Until the trailer is fully rewired from the 4 wire plug to 7-way I'm not using the reverse lights.It take a little bit of an effort to look up replacements so I thought I'd give some part numbers.Both the original and new taillight use the SAE-IST P2-84-DOT (part # 31-84-010) and SAE-AR-84-DOT lens but the original (34-85-750) had a red insert (SAE-P2-85-D.O.T.) in place of the clear reverse lens insert in the replacement (34-85-700).The outside frame (SAE AIP2TST ) was the same except it went from a -84 extension to a -06 on the replacement.
Customer
Reviewed in the United States on February 14, 2022
Good quality, on time delivery, drop in replacement. A real easy upgrade to an older rv.
Val
Reviewed in the United States on December 11, 2022
Rv replacement
Richard
Reviewed in the United States on April 7, 2022
Install was easy enough. The plastic is super cheap, so cheap the clear lenses over the back up light(reverse) pop off. They work without, but it's ugly....
Big Dummy
Reviewed in the United States on May 4, 2021
The old lights had the backup lenses (on both lights) broken from sunlight (5 years old). These are EXACT replacements (same manufacturer), and hopefully last longer.
Ben
Reviewed in the United States on March 15, 2020
These fit great on my 2000 Ford Tioga Motorhome. One was broken so I replaced both with these. The wiring fit the same way my old taillights were wired and they fit perfectly.
Todd Provstgaard
Reviewed in the United States on December 21, 2020
I bought a beat up wells cargo enclosed trailer and I’m re-skinning it with new aluminum siding and lights all around.These lights fit perfectly on the single swinging barn door on the rear.They’re bright, easy to install and high-quality.Recommended A++
brett
Reviewed in the United States on September 12, 2019
Works great nice looking