Your cart is empty.
Your cart is empty.You will see in some of the pictures that the truss fits very tight. Some slight grinding may be required during the installation process. The top caps are CNC cut from 1/4 inch high strength steel plate and is slotted to align the front and back vertical caps. The front and rear caps are CNC cut from 1/8 inch inch high steel plate. The plates are dimpled to add strength and cross section width to the parts. Essentially we can keep the axle a little lighter and make it look very cool with the dimple die holes. The kit includes a short and long side 1/4 inch top cap, two 1/4 inch vertical supports, and five 1/8 inch front and back dimpled plates. This kit requires an experienced welder to install on the vehicle.
Recommended Products
