Your cart is empty.
Your cart is empty. Model: eSwap-A
Hall joystick PCB assembly works with eSwap controller Mini-stick. This Model-A comes with high speed MCU calibration circuit so users can calibrate it after it was inserted in a swappable slot
[Reminders:]
1. Works with eSwap PS, X, XR, X2 and S controller with S2/S5 modules. A little cut on the thumbstick cap might be required for some old S2 plastic enclosure
2. Different slot might use slightly different center settings
3. Solder to short connect the S pads to disable the setting modes after calibration. This is a must if the stick went malfunction caused by the poor contact on the connector
4. The stock enclosure is fragile. Do not pull hard on the corner of plastic bottom plate and never screw in too much
5. Comes with the PCB assembly alone. The plastic enclosure is NOT included
6. Please refer to the video on the same product ID of U.S. Amazon for the demonstration of the installation steps
[3 Choices on eSwap:]
1. This Model-A
2. Model-B comes with TMR stick. An additional calibrator was included to finely reset its center and outer curve
3. The 3rd option is the dedicated calibrator. It calibrates official mini-stick and finely reset the Model-B. Two bare PCBs included for building up new stick assembly. It’s for super DIYers alone. Soldering required. A proper analog, hall or TMR joystick needed but NOT included
What’s in the box:
2x Model-A PCB Assembly
$195.00
$ 90 .99 $90.99
$10.01
$ 4 .99 $4.99
$13.14
$ 6 .99 $6.99