Electronics UIB64 Universal Ignitor Ignition Control Board for Atwood AC/Gas RV Water Heaters with Both 4 & 6 Position Edge Style or 10 Pin Style Connector，Green
$47.99
$47.99
$
21
.99
$21.99
- Performance: Part Number UIB 64 ignition control board is widely adaptable to Atwood ac/gas water heaters with 4 and 6 position "Edge" style or 10 "Pin" style connectors. Through the resetting of jumpers, the UIB64 ignitor board can also fit for old furnaces, water heaters, and fridges since it uses a standard igniter board with a 6-position edge or pin connector by configuring jumpers on the board
- Operation： UIB64 ignition control circuit board is made of high quality plastic and PCB board can restore the lost performance without replacing the entire heater. Operating Voltage：12 VDC, Fuse & Surge protected. The board be helpful in against short circuits in the gas valve and AC relay circuitry
- Design：12 volt DC operation. Including 3 Diagnostic LEDs. Features with local flame sense, so no need of external or remote flame sense wire. Senses the flame through the spark electrode assembly
- Quick Installation：Firstly remember to turn off the power and gas of the RV, then find the location of the ignition board which is in the lower part of the RV. Unplug the ignition cable, 4-pin and 6-pin edge connectors. Remove 2 fix screws of the board and take off the ignition board. Then install the bracket plate of the ignition board, put on 2 screws to fix it, and install the new ignition board
- After-Sale Service：We are committed to providing you with the satisfactory shopping experience. If you have any problems or require assistance, please feel free to get in touch with us. Your satisfaction is always our priority
