Your cart is empty.
Your cart is empty.Product Description
Reason to Choose BILLDIO - Our F32 Grill is Designed - Strict quality control
Grille features a sleek and stylish design that enhances the appearance of your 4 Series F32. Its elegant and sporty look gives your car a custom look that stands out from the crowd.
Our Grille is made from high-quality ABS plastic material that is durable and long-lasting. This material is resistant to corrosion, fading, and impacts, ensuring that your grille stays looking great for years to come.
Our Grille is designed for easy installation, without any drilling or modifications required. You can easily replace your old grille with our product within a few minutes, thanks to the simple installation process.
Compatible With your BMW F32:
Definitely is F32, Please Check the "Amazon Confirmed Fit" Carefully Before
- 2015-2019 BMW 4 Series M4 F82 F83
- 2015-2019 BMW 3 Series M3 F80
- 2014-2020 BMW 4 Series F32/F33/F36 428i 428i xDrive 430i 430i xDrive 435i 435i xDrive 440i 440i xDrive
Gloss Black Single Slat
M Color Single Slat
Gloss Black Double Slats
M Color Double Slats
High-quality ABS Plastic
Grille is made of high quality ABS plastic. It has hard, strong impact resistance, scratch resistance as well as moisture and corrosion resistance.
Robust surface
The surface of the grille is resistant to extreme temperatures and can be used in hot and cold weather.
Make your car unique
Through Simple Replacement Accessory Grille，Gives your A luxurious look that sets it apart from other OEM grilles. Give your car a unique look
Easy to install
No need to drill holes for installation. The sturdy clips keep it well attached to your car.
Seydel
Reviewed in the United States on March 7, 2025
Love the look. Fits pretty good:Sensor mounts/brackets, after test fitting the grill noticed I had to make adjustments to the parking sensor brackets/mounts. You’ll need to break them off and rotate them a little bit so the wire connections are facing straight towards each other to the middle not angled up. The way the manufacturer has them puts a lot of strain on the wires and sensors. The cables are too short to be putting that much tension on the connections and the mounts. Followed directions from a different review (snapped off the two brackets and rotated them a little)-(there not glued on very well or plastic welded to just pop off like that), re-glued (ABS plastic JB weld 24 hr dry time) them and all worked out just fine.Lower clips in the middle are slightly off, had to sand down the edges to get them to clip in-place.It’s been about 3 weeks now and there are a few chips and dings from rock/sand (Normal city driving), micro scratches started showing up now after just 2 car washes and hand dried.Why the manufacturer doesn’t fix this is just insane.
Chris
Reviewed in the United States on February 11, 2025
Terrible. The parking sensor holders came off during install due to cheaply glued. Not solid like on an OEM grill. The angle of the sensor holders is not at 90 degrees. More like 45 degrees that makes it impossible to connect the short sensor wires. With all that, it is 1/4" too small. Leaving a gap on one side and the bottom. Which means the clips don't snap in! What a waste of time. Put my OEM grill back on in 3 minutes. That's how long it should take to unclip the 2 parking sensors and camera. I messed with it for an hour, WAY too long and a waste of my time. Now I have to go through the whole return process. More waste of my time I will never get back.
daniel osorio
Reviewed in the United States on January 11, 2025
Excelente producto remplaza el original y se ve muy muy bien
Paul Sykes
Reviewed in the United Kingdom on April 4, 2025
Very disappointedThought I was buying Quality USA productTurned out. Supplied by a USA company but sourced from China !!Very misleading , also looked very cheap 🤬
Tony G
Reviewed in the United States on September 4, 2024
First of all this grill is difficult to install. 7/10 difficult. First you will need the grill, multiple plastic prybars, metal prybars, a metal pic, flat head screwdrivers, superglue, and a lot of patience. Also if you never worked on a bmw forget it lol. First removing the stock grill is difficult and you don’t have a lot of room to disconnect the camera or parking sensors but it’s possible have patience especially when working the stock grill off. There is a video on YouTube on how to remove the grill without removing the bumper! The the clips that hold the parking sensors into the new grill are at the wrong angle and will not allow you to just plug and play this grill. I used a flat head screw driver to break the small plastic welds holding the clips on the grill and they pop off easy prying a flat head under them. I then used the flathead screwdriver to break off the tiny little plastic posts they used for lining up the clips into the wrong position. They were easy to break off and make the area smooth so the clips can lay back down flat and in the right position. I used super glue to re attack the clips in the vertical position that bmw intended them to be in! You can see them in the vertical position in the pics. Also make sure to check each side of the clip before attaching it to the grill with superglue because each side is different. I double checked the position with the parking sensors and on the stock grill before glueing the clips back on. Once the glue dried I was able to start putting the grill on. Connecting the parking sensors was difficult and I had to use all my finger strength and a prybar to get them into position but they are flush with the new grill as seen in the photos. The camera also was difficult to line up but after having patience and going slowly it went it and is flush! Just remember go slow double check everything and use appropriate force to not break any plastic clips and have patience! I was able to start clipping the grill into the bumper which also took a little convincing but I got it in. I will also be using a black paint pen to cover some of the white bumper where the traffic radar is. Also I’m going to spray paint my radar cover gloss black to match the grill! Goodluck everyone this grill was cheap and cheap for a reason but I’m seriously impressed how I was able to trouble shoot and install the grill. It honestly looks great I hope this message helps someone and this grill is literally half the price of other places for a reason they attached the clips wrong but with this guide and some patience you can have this awesome gloss black grill on your m440i for cheap!
Josie B
Reviewed in the United States on August 18, 2024
The grille inhances the look of the car compared to the stock one but this one has fitment issues with the parking sensors. The tabs that hold it in is not straight so the plug is facing at an angle and the wires behind the grille is so tight there's not enough slack to plug them in. I had to take the wires out of the sleeve that manages them to plug them in. Also the front camera tabs doesn't fit the camera properly it doesn't click in all the way so it's flush with the grille. Looks good but to anyone considering buying this one, don't.
daniel
Reviewed in the United States on May 18, 2024
These fit great and snapped in soooo easy! I've read how some people have gone through all the trouble of removing parts off their cars to install these. Some have even REMOVED their bumper! Wow. Best advice your going to get on how to install these grills, just break your old ones, truth is, they arent worth anything and your gonna end up throwing them away anyways! Once a few vertical members are broken off with pliers, you have access to releasing the 7 or 8 tabs that are nearly impossible to get too unless you have access. Once you get one side off, remove the other side before installing both.
JimnChris
Reviewed in the United States on March 20, 2024
Grille is not made from as dense material as the factory grille but it is sufficiently durable and fits perfectly. A great look for a reasonable price. It looks just like a factory grille, but blacked out with 3 of the vertical strakes in M colors. Be careful not to break the slots on the car as you remove and replace.
Ray Yang
Reviewed in the United States on February 25, 2024
Nice quality, packaging and fitment. Observed no differrences from the more expensive ABS ones.An attractive appearance upgrade for my 440i at a real bargain price without sacraficing quality. Very satisfied with the purchase.
Recommended Products