Shopping Cart

Your cart is empty.

Your cart is empty.

Freshly Baked Style Letter Set for Felt Letterboards, 350 Piece Lowercase Letters + Numbers, Pre-cut, Board NOT included

5.0 Write Review
Free shipping on orders over $29.99

$16.99

$ 6 .99 $6.99

In Stock

1.Style:Lower & Numbers(350pcs)


About this item

  • Will fit all FELT letterboards (Most common style, the center part where letters are placed is made of soft felt material, and typically have a wood frame around the edges.)
  • Will fit some PLASTIC letterboards. (The center part where letters are placed is a flexible plastic) Fit test instructions below.
  • Will NOT fit most WOOD letterboards. (The entire board is rigid wood, with slots in the wood for placing letters) Fit test instructions below.
  • All pieces are "pre-separated", no scissors or cutting needed.
  • The small lowercase letters vary in height but are appx .55" tall (a,e,o, u) etc. The taller lowercase letters (h,b,d, etc) and numbers--if purchased--are about .8" tall.
  • These are slightly smaller than most .75" letters that come with letterboards. Check listing images for size comparison.


Product Description

Letterglyph, Your board, your letters
Pre-cut, Smooth Edges, Made In USA with imported materials
Board Types, Felt, Plastic, Wood

Will Letterglyph pieces fit in my wood or plastic board?

Peg size 1.5mm

Sizing

  • Letterglyph pegs are appx 1.5mm thick (but vary individually)
  • US pennies are also appx 1.5 mm thick (but vary individually)
Wood Board Line Spacing

Letterglyph letters (particularly the cursive sets) look best if the lines on your board are spaced approximately .25" apart from each other.

Some wood boards from major retailers have lines spaced approximately .5" apart from each other. Letterglyph letters will NOT look good on these boards. The letters may appear uneven and not flow together nicely.

Get 5 recently minted US pennies and insert them into your board. Try different pennies in different grooves as some wood boards have varying groove widths.

Wood Board:

If the pennies will not fit or are a little tight, Letterglyph pieces will NOT work. The grooves are too small.

If it’s easy to insert and remove the pennies with no resistance, Letterglyph pieces will fit your board. You’ll still need to be careful inserting and removing pieces to avoid peg breaks.

If the pennies are loose and wiggle in the slots, Letterglyph pieces will be loose in your board.

Plastic Board:

First test insert a penny into a corner of your board in case the plastic deforms. If there is no damage, proceed to test the remainder of the pennies across your board.

If the pennies press in and remove with just a little pressure than Letterglyph letters will work for your plastic board. If it’s difficult to insert a penny, or the plastic permanently deforms, then Letterglyph letters are not compatible with your board.