Shopping Cart

Your cart is empty.

Your cart is empty.

Front End Suspension Rebuild Kit Compatible with Chevrolet C10 P10 OEM Spec Replacements (16 Piece Kit)

5.0 Write Review
Free shipping on orders over $29.99

$279.99

$ 99 .00 $99.00

In Stock

About this item

  • YEARS: 1963 and 1964
  • MODELS: Compatible with Chevrolet C10 and P10 Series
  • HIGH-QUALITY: OEM Spec Replacements
  • INCLUDED IN THE 16 PIECE KIT: Inner Tie Rods (2 Each), Outer Tie Rods (2 Each), Tie Rod Sleeves (2 Each), Sway Bar Bushings (2 Each) - 17.5 mm (0.68 Inch), Upper Control Arm Shaft Kits (2 Each), Lower Control Arm Shaft Kits (2 Each), Upper Ball Joints (2 Each), Lower Ball Joints (2 Each)
  • ALSO CONTAINS: The Cotter Pins, Rubber Grease Seals/boots, Zerk Fittings (When Applicable), And The Bolts For The Ball Joints, Plus The Tie Rod Sleeve Bolts, Nuts, And Clamps.


This Kit is constructed using High-Quality OEM spec replacements for 1963 and 1964 Chevrolet C10s and P10s. These parts are Factory Design and will only work with Stock Vehicles. This Kit Contains All Of The Pieces Below: Inner Tie Rod Ends (Right and Left), Outer Tie Rod Ends (Right and Left), Tie Rod Sleeves (2 Each), Sway Bar Bushings (2 Each) - 17.5 mm (0.68 Inch), Upper Ball Joints (2 Each), Lower Ball Joints (2 Each), Upper Control Arm Shaft Kits (2 Each), and Lower Control Arm Shaft Kits (2 Each). This Kit Also Contains The Cotter Pins, Rubber Grease Seals/boots, Zerk Fittings (When Applicable), And The Bolts For The Ball Joints, Plus The Tie Rod Sleeve Bolts, Nuts, And Clamps.