Your cart is empty.
Your cart is empty.The General Tools 881 E-Z Pro Crown King Molding Jig with Protractor can produce perfectly mitered interior and exterior crown molding joints.
Robert D
Reviewed in the United States on March 4, 2025
This is a must for precise cutting. Easy to use
Pgh Mom
Reviewed in the United States on February 28, 2025
This works like a charm. Practice with some scrap molding. Hold firmly in place and go slow with the miter saw cut. Amazed with results.
Deborah
Reviewed in the United States on February 11, 2025
The included protractor is totally useless. Measures interior corners whose angle is greater than 90 degrees as Less than 90 degrees. Super frustrating. Otherwise, this is a decent tool/kit so far
Go Cats
Reviewed in the United States on August 17, 2024
First time doing crown molding and saw how tricky getting the angles correct are when cutting flat. One of the tutorial videos mentioned this little gem. It holds the crown molding at the correct mounting angle while you make the cuts. Highly recommended to use with your miter saw.
Informative
Reviewed in the United States on July 26, 2024
Better than other options.
Mr. B
Reviewed in the United States on February 22, 2024
Can I give it ten stars?1. Made in Canada2. Instructions have clear numbered photos of typical 90 degree inside-outside and left-right situations then simple markings on the tool to match each picture. Brilliant!3. Takes all the hassle out of crown miters. No more "turn the crown upside down and backwards" confusion.4. Adapts to 45 degree (most common), 38 degree, and 52 degree crown moldings. Excellent.Even easier than a compound miter saw IMO.
J. Duijvestein
Reviewed in Canada on March 3, 2023
Instructions were simple and clear. Easy to use. Great results
Brian
Reviewed in Canada on July 24, 2020
Turned me into a pro overnight. Very straight forward. I still made mistakes but only because I don't know the difference between left and right, inside and outside. Over time I managed to slowly cut away the device in my miter saw so you need to be aware of it when cutting mouldings. Little slices-nothing that ruined the device. The protractor was useless. It kept falling apart. I stopped using it 20 minutes in. I am very happy to have purchased this item.
jason b
Reviewed in Canada on March 8, 2020
Never tried to do crown molding, angle measurements seemed like a chore to me. This jig made me look like a 20 year pro. Just great. So pleased with results.
Alan Czerkaszyn
Reviewed in Canada on February 19, 2020
Using the guide allowed for a single cut to get the proper angle. be sure to find a You tube video on using the guide and be clear that the right and left marks refer to right and left of the joint .
Tony Herron
Reviewed in the United Kingdom on December 30, 2019
Good for holding onto work peice
B.K.A
Reviewed in the United States on November 18, 2019
I have only used this for inside joints, but it works as described. It is accurate and allows for much more consistent cuts. You need to use the included angle finder, don't assume your corners are true 90, most are not. Instructions are good and are illustrated. I kept them with the jig and saw until I had done it enough to remember which way the table and jig go depending on the side of the cut. This makes crown molding very doable with just a chop/miter saw and not much more. Glad I found this, worth the investment.
H. Bryo
Reviewed in the United States on October 8, 2018
I wish the maker could spend a lil more time and money on instructions. I had to go on youtube to see how one guy uses his. his instructions are way better than the ones from the manufacturer
Recommended Products
