Shopping Cart

Your cart is empty.

Your cart is empty.

iFJF Fan 50 Plus Pins Ignitor Control Board with Fan Control for 12 V DC Furnaces

5.0 Write Review
Free shipping on orders over $29.99

$49.99

$ 24 .99 $24.99

In Stock
  • Fitment: The fan 50+ pin igniter control board for 12 V DC furnaces only.
  • Compatibility: Compatible with the following Furnaces: 7912-II, 7916-II, 7920-II, 8012-II, FA 79D, HF 80D, DC82 25-32, DC82 35-41, FA 76D, FA 78 25-32, FA 72D, 8500-IV Series, 8500-III Series, 85-II Series, 85-I Series, 8900-I DC Series, 8900-II DC Series, 8900-III DC Series, AFSD12, AFSD16, AFMD20, AFSD20, AFMD25, AFMD30, AFMD35, DFMD30111, DFMD20111, DFMD25111, DFMD35111 DFSD12111, DFSD16111 and DFSD20111.
  • Energy Efficient: Use this board to upgrade an old furnace to add fan control functionality. If the fan control ignition panel does not detect a flame after the third ignition attempt, the fan motor will automatically shut off.
  • Easy to Install: You can easily install the circuit board to prevent unnecessary cold air from blowing out, which improves the efficiency of the unit.
  • Size: 3.2" x 4.25" | Voltage：12 VDC Operation | Flame Failure Response Time:0.8 seconds maximum |Tries for lgnition: Three| Operating Temperature: -40 to + 176°F(-40℃ to +80℃).



The ignition control board is compatible with Dinosaur Electronics/Atwood/Suburban/HydroFlame series furnace with fan control:


7912-II, 7916-II, 7920-II, 8012-II, FA 79D, HF 80D, DC82 25-32, DC82 35-41, FA 76D, FA 78 25-32, FA 72D, 8500-IV Series, 8500-III Series, 85-II Series, 85-I Series, 8900-I DC Series, 8900-II DC Series, 8900-III DC Series, AFSD12, AFSD16, AFMD20, AFSD20, AFMD25, AFMD30, AFMD35, DFMD30111, DFMD20111, DFMD25111, DFMD35111 DFSD12111, DFSD16111 and DFSD20111.


SF20/25/30/35/42, SF20F/25F/30F/35F/42F use 520832 wire kit, NT24/30/34SP, NT40 use 520839 wire kit, NT12/16/20S, NT12/16/20SE use 520840 wire kit, DD17DSI with date comes below 9124 use 520612, DD17DSI with date comes above 9124 use 520741. SW4D, SW6D, SW6DE, SW6DEL, SW6DEM, SW6DM, SW10D, SW10DE, SW10DEL, SW10DEM, SW10DM, SW12D, SW12DE, SW12DEL, SW16DEM, SW16DEL, SW16DEM and other vehicles.


Features: The "Fan Control" feature must be used for proper operation of this board.


Upgrade an older furnace to add the Fan Control feature, which shuts off the fan motor if the board does not sense a flame after the third ignition attempt.