Shopping Cart

Your cart is empty.

Your cart is empty.

JCP USA Slip-Over, Cool Sleeves, Aluminum Metallic Heat Shield Sleeve Fiberglass Insulated Wire Hose Cover (Hook & Loop 31-37mm 1-7/32”-1-15/32” Aprox. I.D., 6 Foot)

5.0 Write Review
Free shipping on orders over $29.99

$18.99

$ 9 .99 $9.99

In Stock

About this item

  • JCP Cool Sleeves Quality Heat Treated Fiberglass, Silicone Bonded to an Aluminum Alloy Skin. I.D. = Inside Diameter
  • Designed to provide maximum heat reflectivity while also protecting from chemical, oil leaks & spills, dirt, road grime and other under hood hazards.
  • Better than Heavy Silicone Tape, Sleeves are Lightweight, Hook and Loop Seam Fastener makes for an easy install, removal & adjustment.
  • Reflects over 90 % of Radiant Heat, Fireproof, Oil Resistant, lightweight, Pliable for a tight fit. Rated for MODERATE Heat: Not recommended for use on or against headers, exhaust pipes or extremely hot surfaces (The melting point of the Hook & Loop fastener is about 325Fº) Can be used in about 90% of the under hood area when installed with a realistic design sense in mind.
  • Included is our Aluminum Termination Tape. Use it to give a finished edge and seam to your sleeve. Secure your work. Tape can be cut in strips to maximize coverage


Cool down with JC Performance Cool Sleeves. Available in multiple lengths and diameters to fit: wiring, fuel lines, brake lines, intake tubes, intercooler pipes, spark plug wires, battery cables, A/C hoses, radiator hoses and more. Easy to trim. Hook and Loop fastens right over existing wires, cables and hoses, Sewn Seam slides over wires, cables and hoses. For best results seal the sleeves at each end with adhesive tape (Included), shrink tube or use stainless cable ties. To ensure a proper fit, allow extra room for bends (for example: a 90º bend in a 3/4" tube will NOT fit in 3/4" I.D. Sleeve, In this case you would need 1" I.D. or higher) I.D.