Your cart is empty.
Your cart is empty.JY-S60 Weight Sensor Transmitter ManualTechnical parameter.Working voltage: 24VDCOutput signal: 0-5V, 0-10V, 4-20mA.Input sensor sensitivity: 1.0mV/V, 2.0mV/V Operating temperature range: -20-80.Working environment humidity: 10%RH-90%RH (no condensation) Accuracy: better than 0.2%F.SGear selectionWhen DIP switch No. 1 is turned OFF, VO outputs 0-5V, when No. 1 is turned ON, VO outputs 0-10V, and when both DIP switches 1 and 2 are turned OFF, VO outputs 0-5V, IO Output 4-20mA. The other wire for current and voltage output and the negative pole of the power supply are both GND. If the zero point cannot be adjusted, you can try to turn the DIP switch 2 to ONZero adjustment1: Voltage adjustment Connect the sensor, first make the system in no-load state, adjust the voltage zero potentiometer (Vzero) to adjust the zero point. Use a multimeter to measure the voltage at the output terminal VO, and make the displayed value as close as possible to the zero point.2: Current adjustment Connect the sensor, first make the system in the no-load state, adjust the current zero potentiometer (Izero), measure the output current IO with a multimeter current block, and try to keep it as close to 4mA as possible. .Product parameters:Item model number: JY-S85Input signal: full bridge strain sensor (weighing force tension pressure sensor)Power supply voltage: DC18-26VInput sensitivity: 1-3mV/VSensor excitation voltage: 5-10mV/V adjustableOutput signal voltage and current: DC0-5VOR0-10V/4-20mAShipping list:Load Cell X1current load cell load, Sensors, Active Components, Electronic Components & Supplies
$169.76
$ 75 .99 $75.99