Shopping Cart

Your cart is empty.

Your cart is empty.

MECCANIXITY 14Pcs DIP IC Chip Socket Adapter, 2.54mm Pitch 40 Pin Gate Soldering Flat Circuit Chip

5.0 Write Review
Free shipping on orders over $29.99

$6.89

$ 3 .99 $3.99

In Stock
  • IC Chip is a small circuit board made of semiconductor materials, which gathers a large number of electronic components, and is connected by wires and metal lines to form a complete circuit system.
  • Pitch: 2.54mm/ 0.1"; Number of Pin: 40; Row Distance:: 15.2 mm; Material: Plastic, Metal; Total Size: 51 x 18 x 8 mm/2"x 0.7" x 0.31"(L*W*H); Package Content: 14Pcs x DIP IC Chip Socket Adapter Circuit Chip
  • When you need to install or replace the chip, directly remove the connection between the IC socket and chip, achieving the effect of reducing IC cost and time.
  • The IC socket achieves the chip can be pulled and inserted directly without soldering to the PCB board. It has heat resistant and good pin stability and can withstand repeated assembly and disassembly without damaging the chip.
  • The spacing and line spacing of the connector holes must be the same as the spacing and line spacing of the chip pins.


What is this?
IC Chip is a small circuit board made of semiconductor materials, which gathers a large number of electronic components, and is connected by wires and metal lines to form a complete circuit system.
What will I get?
Pitch: 2.54mm/ 0.1"
Number of Pin: 40
Row Distance: 15.2 mm
Material: Plastic, Metal
Total Size: 51 x 18 x 8 mm/2" x 0.7" x 0.31"(L*W*H)
Package Content: 14Pcs x DIP IC Chip Socket Adapter Circuit Chip
Are there any advantages of the product?
The IC socket achieves the chip can be pulled and inserted directly without soldering to the PCB board. It has heat resistant and good pin stability and can withstand repeated assembly and disassembly without damaging the chip.
How to use it?
The IC socket is the carrier between the chip and the PCB circuit board, the chip can be pulled and inserted directly without soldering to the PCB board.
What should I notice?
The spacing and line spacing of the connector holes must be the same as the spacing and line spacing of the chip pins.