Your cart is empty.
Your cart is empty. The DDM Tuning D2S Projectors are what retrofits are made for. Each projector is hand picked to ensure the highest quality.
Beam Pattern: The V2 D2S Projectors have a wider beam pattern than the V1 D2S Projectors to give more output on the sides of the road below the cutoff. Incredibly sharp cutoff. The hot spot is located right at the cutoff to give phenomenal low and high beam output. The width rivals that of the IFX projectors but allows for easier installation.
Construction:
Lens: Optically clear Grade A glass. Only the best lens is used for these projectors.
Lens Holder: Make of a high temp nylon / fiber glass composite to withstand up to 220 celsius (438 F).
Solenoid: We use a large (strong) magnetic solenoid that will pull the high beam shutter all the way to allow more light output when on high beams. With the larger solenoid we designed a deeper high beam that will illuminate further down the road.
Reflector Bowl: After casting the mold each reflector is polished smooth to remove any imperfections then coated with a high temp chrome coating that is again polished to a mirror finish to reflect more light forward. The chrome coating can withstand the heat from both 35W and 55W HID systems without burning or yellowing over time.
Mounting: H4 plates are included at no charge to allow for easier installation. Comes with rubber gaskets to properly seal the projector in place.
Warranty: All DDM Projectors come with a lifetime warranty.
Kit includes:
2 x D2S Projectors
Mounting Hardware (H4 plates)
Gasket
Width: 103mm
Height: 79.4mm
Length: 143.5mm
