Your cart is empty.
Your cart is empty. Product Introduction
This module is a voltage and PWM conversion module. PWM digital signals are converted into O to 10v analog signals. By adjusting the PWM duty ratio to adjust the output voltage, V-PWM can be 0-5V-10V voltage into Chen Baoguo 0-100% PWM output, by adjusting the voltage to adjust the PWM duty ratio. The module size is small and easy to apply in different places.
Product parameters
PWM conversion voltage:
Module operating voltage :DC 12v-30v; (Power requirement: greater than 100MA)
PWM signal receiving frequency range :1KHZ-3KHZ;
PWM signal input level range:
Peak-peak value is 4.5V to 10v, and the jump pin is inserted at 5V. This kind of level signal is mainly for the conventional industrial control card (such as MACH3 board),5V CPu interface;
Peak-peak value 12 to 24v level, the jump pin inserted at 24V. This type of level signal is mainly for the conventional PLC interface.
Conversion range :0%-100%PWM conversion to O-10v voltage Allowable error :5%.
Voltage to PWM:
Module operating voltage :DC 5V-12V
Output PWM frequency: about 50KHZPWM amplitude :5V
Conversion range :0-5V/0-10V
Voltage conversion :0%-100%PWM
Pin Description
VCC: The working power supply is 12V to 30V.
GND: indicates the working power source.
PWM: Input PWM signal positive end. GND: negative end of the input signal.
VOUT: Output voltage 0-10V.
GND: indicates the output voltage ground.||||
$98.36
$ 47 .99 $47.99