Your cart is empty.
Your cart is empty.
Set of 4 new spark plug resistor covers replaces the now discontinued VD05F and SD05F. For the SOHC CB750 from '69-'78. Use this kit with the stock points ignition or an electronic ignition.
- Rubber waterproof boots to seal out the elements, so the engine won't cut out if it rains.
- For use with 7mm diameter plug wires
Installation tips:
Remove terminal nut before installing new spark plugs. It's screwed onto the top of the spark plug.
Put a light coating of anti-seize on the spark plug threading before installing. After all, you're threading a steel part into a aluminum engine case.
Don't over tighten the spark plug, 1/8 to 1/4 turn past finger tight.
When using the old spark plug wires, trim them back 1/4" - 1/2" to expose fresh wire, then using a pick type tool, fan out the wires before threading on the new resistor cover.
Twist on the new cover about 3 full turns and give it a tug to make sure it's snug.
Replaces Part Numbers: 8052, 8022
Replaces Honda Part Numbers: 30700-MW3-000, 30700-GAR-000
Fits Honda:
CB750A Hondamatic - 1976-1978
CB750F Super Sport - 1975-1978
CB750K - 1969-1978
$12.01
$ 5 .99 $5.99