Your cart is empty.
Your cart is empty. Electrical cartridge heater of maximum durability. Cartridge Heater with high compressed load.
Installation
- Indicate with symbols the warning of hot surfaces.
- Store as protected from moisture as possible.
- Cut off the total current to the machine or mold.
- Check that the machine or mould is at room temperature.
- Introduction without any type of anti-seize paste.
- Holes with H7 tolerance only
- Attach regulation and cutting systems (thermocouples and regulators)
- Insert 100% of the cartridge's sheath length.
- Do not insert the connection cable inside the hole
- Protect the cables and connection input from: shocks, splashes and excess material .
- Do not pick up or carry the cartridge on the cable.
- Keep the cable away from the heat source and protected from it.
- Do not repair damaged cables. Replace them with new ones identical to the original ones.
- Indicate and send the working conditions (vibration, shocks, humid environments) in writing before accepting the order.
- Never leave in operation without qualified human presence.
- All exposed parts are compulsory for the safety of persons and goods.
- Never connect outdoors.
