Shopping Cart

Your cart is empty.

Your cart is empty.

10pcs Rail Terminal Iron Plug Clamping Rail Single-Layer Terminal DIN Rail Mount Terminal Blocks End Stopper

4.4 (1) Write Review
Free shipping on orders over $29.99

$9.99

$ 4 .99 $4.99

In Stock

About this item

  • It is made of cold rolled steel plate by die-casting, and the surface is galvanized. It is durable, strong in oxidation resistance, and not easy to corrode.
  • Dimensions: 45 x 20 x 9mm/1.77 x 0.79 x 0.35 inch, suitable for mounting 35mm wide rails
  • Easy to install, screw in the screws, insert the wires, and tighten the screws.
  • The terminal strip is used as a distribution box or cabinet and other general terminals, such as household appliances, electronic circuits, factory workshops, distribution boxes, etc.
  • Package: 10 x DIN rail terminal block


Specification:
Product: DIN Rail Terminal Block
Wiring mode: fixed by screws
Dimensions: 45 x 20 x 9mm/1.77 x 0.79 x 0.35 inches
Color: silver, color plated
Package: 10 x Terminal Block
Installation instructions: To prevent the terminal block from sliding or falling off the DIN rail, it must be fixed on each side. This is done by screwing the end bracket onto the rail. Two end brackets must be used, one on each side of a continuous assembly designed.


MI
Reviewed in the United States on November 17, 2024
The product didn’t work as well as I’d hoped for my specific application. If you’re using them toward the middle of the bar, they might be fine, but I was using them on the ends to hold my breakers tight together, and they were tricky to manage. They’re hard to keep in place at the ends without falling off. You have to slide them on and lift the piece while trying to tighten them, which is a bit of a hassle. For now, I plan to switch to the other type of plastic ones that might work better for my needs.