Your cart is empty.
Your cart is empty. This is For A BRAND NEW 1/2" Phenolic Plastic Carb Spacer And Stud Kit For 4150 Series Carbs
Fits Holley, Edelbrock, Barry Grant (Demon), Chevy, Ford, Mopar and any other square bore carburetor
Keeps Heat Out Of The Carburetor And Gets More Horsepower
1/2" Total Height
Kit Comes With Everything Needed For Installation
Kit Contains (as pictured):
- (1) 1/2" Phenolic Plastic Spacer,
- (2) Gaskets,
- (4) Bolts,
- (4) Washers,
- (4) Nuts
Popular Make Fits: Chevrolet, Fort, Chrysler, Oldsmobile, Pontiac, Holden, and MorePopular Engine Sizes: 253, 289, 302, 304, 308, 318, 326, 350, 351, 360
AmAz0n CuSt.
Reviewed in the United States on January 25, 2025
Fit my Intake
Kindle Customer
Reviewed in the United States on March 3, 2024
None of the holes line up on the spacer or gasket. If your handy you can make it work with a little filing.
Tom Ranieri
Reviewed in the United States on October 5, 2021
Product was packaged well, fit as stated and studs were high quality.Fit right under my FiTech throttle body on an Edelbrock Big Block Mopar intake with any issue.Nice job on manufacturing this unit.
jaclyn tolliver
Reviewed in the United States on January 7, 2019
Good stuff
Customer
Reviewed in the United States on April 29, 2019
Looks to be of good quality fit perfect
Marc
Reviewed in the United States on April 28, 2019
It does the job but the quality of the material is marginal.
kameron
Reviewed in the United States on April 14, 2018
Couldn't run a 1" spacer but this worker perfectly
Dave Y.
Reviewed in the United States on September 11, 2016
Spacer and gaskets fit fine. The studs are about .5" too short to use, at least with an Edelbrock carburetor. But I sorta figured, based on the picture, that that was gonna be a problem. The nuts are an interesting combination of standard 5/16 fine threads with a metric 12mm hex size.
Recommended Products
$46.65
$ 20 .99 $20.99
$70.99
$ 28 .99 $28.99