Your cart is empty.
Your cart is empty.1/2" PEX Plastic Bend supports are used to make a smooth 90-degree turn with PEX tubing where needed. Manufactured from fiber-reinforced plastic for extra durability and holding power. Simply lock the tubing inside the bend support and done.
Customer
Reviewed in the United States on May 14, 2017
A bit light but with a little pre bend of the pex holds it just fine!
joe
Reviewed in the United States on January 16, 2017
easy to use
C. Fowler
Reviewed in the United States on February 23, 2016
Interesting invention. Fairly costly if you use a bunch!
JULIE
Reviewed in the United States on August 19, 2015
Did not hold the pex tubing in place very well. Kept popping out.
Robert W.
Reviewed in the United States on May 26, 2015
GOOD SELLER, WORK AS THEY SHOULD.
Texian
Reviewed in the United States on March 4, 2015
This item indeed performs as it is intended to do so but there is one thing that could/should be changed. This is an issue with the design of the item and certainly not the quality. I have modified all of my bend supports by clipping out a 2mm notch about 3mm from each end. This notch allows for me to use a zip-tie or cable-tie to hold the PEX tubing in place and not slip out which they are prone to do. Had this notch been made part of the mold during manufacture, it would be a 5 star item. If you do not notch it yourself, you can still use a zip tie but the results are not as secure. IF you do not use any kind of tie or tape to secure the PEX in place, there is a 60 percent chance that the tubing will slide out at some point.
Customer
Reviewed in the United States on March 1, 2015
These bend supports worked great and if was not the right amount of 90 degree leg just pop it off and reposition. Note if it is 40 degrees or lower you may need to warm pipe if using 3/4.
Recommended Products
$27.99
$ 12 .99 $12.99