Your cart is empty.
Your cart is empty. HUAREW High Quality Mower Potentiometer Classification Kit
Electrical parameters:
Resistance range: 100~500K Ohms
Rated power: 0.5 W
Maximum operating voltage: 300 V
Operating temperature range: -55°C ~ + 125°C
Temperature coefficient: ± 200 ppm/° C.
Resistance Distance: ±10%
Resistance change features: B
Quantity per pack:
101--------100Ω----5pcs
102--------1KΩ----- 5pcs
103--------10KΩ----5pcs
104--------100KΩ - 5pcs
201--------200Ω----5pcs
202--------2KΩ------ 5pcs
203--------20KΩ----5pcs
204--------200KΩ - 5pcs
501--------500Ω----- 5pcs
502--------5KΩ------- 5pcs
503--------50KΩ----- 5pcs
504--------500KΩ---5pcs
Bruno Salvatore
Reviewed in Italy on April 28, 2025
L’articolo corrisponde alla descrizione
eric.tech
Reviewed in France on March 4, 2024
Facile d’emploi
Simon Clegg
Reviewed in the United Kingdom on February 7, 2024
I assumed these would be low quality, but they seem to be ok.
Kunde
Reviewed in Germany on October 15, 2024
Gutes Produkt.
RonB
Reviewed in the United States on March 21, 2023
The box assortment of trimmers were as advertised. They are individually easy to identify and fit into a breadboard nicely. Making adjustments to them while plugged in is a little more challenging as they tend to be a little wobbly, they do however save horizontal space. The tradeoff isn't inconvenient. Next time I will buy a flatter version for use in my breadboards. These trimmers are excellent for use in a soldered PCB board.
Lunix
Reviewed in the United States on December 21, 2023
2023-12-16: The leads are normal-sized and normal in every other way contrary to some earlier posts. They're spaced 0.1" apart (as usual). But the values of the resistors aren't consistent and some aren't within 5% of the stated values: The first 100K one I measured is 107.1K.
Jose Elias
Reviewed in Spain on January 28, 2023
ES LO QUE SE ESPERA.
Customer
Reviewed in the United States on December 7, 2022
No parts no problems
Bill Wichser
Reviewed in the United States on December 3, 2022
Connecting pins are all quite bent up. I'd like a larger diameter pin which would both stop this problem and give these pots some better longevity for prototyping. If you're soldering to a board then these should be adequate once you deal with the pins.
Recommended Products
