Shopping Cart

Your cart is empty.

Your cart is empty.

1986-01 Cherokee (XJ Series) and Wagoneer (Midesize) 4DR Outer Rocker Panels (Pair)

Free shipping on orders over $29.99

$129.99

$ 62 .99 $62.99

In Stock
  • Replaces outer rocker sections for the Jeep 1986-01 Wagonner and Cherokee 4DR
  • Made from 18ga automotive steel for extra durability
  • Made by the most trusted manufacturer of rust repair panels
  • Made in the USA
  • Replaces both driver's and passenger's side


Replaces outer rocker sections for the Jeep 1986-01 Wagoneer and Cherokee 4DR


BeeJay
Reviewed in the United States on October 3, 2022
Came well packaged and great product. Thank You!
Stu
Reviewed in the United States on March 2, 2021
These are great!! Just a little tweaking (had to bend the bottom up just a little bit) to fit back to the inner rocker but very awesome product. Shipping was pretty good and the price was great!!! Would recommend to friends and purchase again. Thanks.
RjHernandez
Reviewed in the United States on September 9, 2020
Great parts , great price!
Customer
Reviewed in the United States on September 16, 2020
I started to put these on a 1994 jeep XJ and stopped ! They butt up to the front fender to give a body line but the front is left open it doesn't go under the fender into the nose cone. The inner rocker panel is 6 inches wide these measure 7 inches wide, but they do fit, the material is a heavy gauge are they worth $75.00 ? Yes. It's not necessary to take the doors off but I replaced the inner rocker panels and floor pans too just made welding easier
Unknown
Reviewed in the United States on October 29, 2020
Not the greatest fit but after a good amount of trimming bending and welding they went on
Robert
Reviewed in the United States on June 10, 2017
I can kind of see what the other reviewers mean, but these rocker panels are NOT too long. They do, however, need to be notched at the back on the step inside the back door where the wheelwell starts to curve upward, as these just go straight back. As far as the face that you see and the bottom, they are the correct length. You do have to take out the screw underneath that holds the end of the plastic fender flares, as these need to go under the flare. It took me longer to get the plastic trim inside off and out of the way than it did to notch and fit these in place. I am happy with them, now my 1998 Cherokee doesn't have holes in the rockers anymore.
Bill zoodie
Reviewed in the United States on December 30, 2015
Very good quality
The Dude
Reviewed in the United States on February 18, 2014
Do not fit. At least on a 1994 jeep cherokee they are much too long and don't quite match the body lines.