Shopping Cart

Your cart is empty.

Your cart is empty.

2 Urethane tires specifically made for 14' Ridgid Band Saw Models BS1400, BS14001 & BS14002

Free shipping on orders over $29.99

$36.95

$ 19 .99 $19.99

In Stock

About this item

  • Heavy Duty Urethane .095" Thick
  • Bright Orange for better blade inspection
  • Manufacturer's Lifetime Warranty
  • Made in USA with USA materials


2 Urethane tires specifically made for 14" Ridgid Band Saw Models BS1400, BS14001 & BS14002


Mike P.
Reviewed in the United States on April 15, 2025
Very Nice I would buy again.
mark
Reviewed in the United States on June 10, 2022
Used on a Rigid 14 inch bandsaw. Easy to install and haven't had any issues. Highly recommend.
Customer
Reviewed in the United States on May 26, 2022
These worked out great. I was replacing original tires on my band saw these are a great improvement. It takes some effort to install them and after all the tips in the instructions, I still needed to get out my locking pliers (Vice Grips) and clamp the top and sides to pull the tire down. That worked fairly well. Then I went back to the tips to even out the tire all around. It was a good purchase and with the addition of the locking pliers a relatively easy task. And they work GREAT!
Customer
Reviewed in the United States on June 8, 2021
These bandsaw tires are excellent. Good quality, heavy duty, nice tight fit on the wheel when following the enclosed instructions. Would definitely purchase again.
Larry
Reviewed in the United States on February 4, 2020
The tires seem very nice. I installed them without using hot water, which the manufacturer warns against, by stretching and then holding the tire on the wheel with two rubber faced clamps, and finally stretching the rest of the tire over the wheel with two dowels. My only concern is the joint in the tire. It seems the tire is fused into a circle, so there's an area where the two ends meet. On both tires there was a flat spot where the joint was buffed down. You can see that area in the photo, it's lighter in color. One of the ties is also narrower here, which is easily seen. I'm curious if this is a weak spot.
Porkchop
Reviewed in the United States on February 15, 2020
These tires were very easy to install by following the included direction to use tie wraps to hold one size on while you stretch the other side. No need to use hot water or soap or anything like that. I could of installed while leaving the wheels installed but chose to remove them to clean and inspect the wheels and bearings.Longevity is a pretty silly review area. I'll check back in year and let you know.
Craigenstein
Reviewed in the United States on April 10, 2020
Finally, an American made product ! The quality shows. These fit my Rigid 14-inch band saw (BS14002) PERFECTLY (that means laterally inside the lip on the circumference of the wheels, as well as the actual circumference itself). Some reviews seemed to have a problem with the "weld" (seam to join it together). Both of my tires had a weld that was almost invisible and did not have a flat spot. Installation was a bit tough, but that is because these tires are quality and sturdy ! I did NOT use hot water (as they would be damaged...DO NOT LISTEN TO OTHERS WHO USED THIS INSTALLATION METHOD). I used 2 zip-ties to hold it in place, then a small (5") section of a 1/2" diameter wood dowel and rolled it under the tire while rotating the wheel, and it installed in less than 1 minute each. I did need the help of my wife to rotate the wheel as I rolled the dowel. Just by replacing the wheels, my balance was much better. Very happy with my purchase, and I would definitely recommend.
Igoplaying
Reviewed in the United States on November 6, 2019
I installed the tires without removing the wheels, I used zip ties to hold about 75% of the tire in place so I could use both hands to finish stretching the tire over the wheel. Installation took about 10 minutes per tire. The fit is excellent. I am very pleased with the product. I didn’t leave a review about longevity as I don’t know yet but I do think they will last