Your cart is empty.
Your cart is empty.Give your Vehicle that special look! QMI Custom Fender Trim is made of high grade mirror polished Stainless Steel. QMI Wheel Well Trim requires minor drilling on underside of wheel well. No unsightly holes. Installation is safe and easy. Comes with self tapping screws for a secure fit. Each Fender Trim piece has a rubber seal guard already attached and glued from end to end for vehicle protection. Each QMI Wheel Lip Molding has pre drilled holes for easy installation. Each piece is guaranteed to fit without trimming or bending. Simple installation instructions are included with every set. QMI Wheel Arch Moldings enhance the appearance and value of every Vehicle. Beautiful Fender Trim adds extra shine to the look of your Vehicle at an affordable price! Make heads turn with all of QMI Custom Stainless Steel Accessories. Not an original Factory equipment replacement item.
John Milner
Reviewed in the United States on August 31, 2019
They fit the wheel arches perfectly but fall short somewhat as the part that mates with the fender well lip is barely long enough to permit installation of the screws. In fact, the fronts were so bad I couldn't use 4 screws and made do with 3. I did get them installed and they look great! I used a "C" clamp and block of wood to hold the moulding to the truck. Be careful as the moulding will dent if the clamp is over tightened! I would purchase again.
Clip
Reviewed in the United States on May 18, 2017
Easy to install and looks great
Recommended Products
$139.95
$ 57 .99 $57.99