Your cart is empty.
Your cart is empty.Product Description
Method of Use:
1. They are bent and bonded and will need to be fully welded
2. Simply remove the front suspension and crossmember, measure and drill locating pin holes in the bottom of the frame
3. Then jack up the new Crown Vic suspension, then cut into the top of the frame, slide those brackets in and bolt them together
4. Finally, the seams are completely welded and the brackets are welded to the frame
1. Replacement for:
Replacement for Crown Vic
2. Package Included:
2 x Raw Steel Swap brackets (left and right)
3. Note:
Please check that the product matches your needs and make sure you will not receive the wrong model
shane young
Reviewed in the United States on January 20, 2022
This welded up very nice.
Recommended Products