Your cart is empty.
Your cart is empty.TapeCase Polyester Tape-Converted from 3M 8992, is a 3.3 mil industrial grade tape specially designed and manufactured for high temperature applications like powder coat masking, flash breaking and bag sealing. Featuring a distinctive green color for excellent visibility along with resistances to chemicals and abrasion, this product is also suited for splicing, tabbing and roll closing applications.
Elvira Lover
Reviewed in the United States on February 7, 2020
The adhesive isn't good, it doesn't stick well.
Big Chuck
Reviewed in the United States on December 25, 2020
Tough stuff
Robert Sumter
Reviewed in the United States on June 17, 2015
Shipped quickly and it was green tape, all good
Yoshi
Reviewed in the United States on February 5, 2015
Unless I got a dud, I would not trust this stuff as far as I can throw it. The tape is rolled onto the spool very inconsistently, making tons of bubbles and bumps that will not adhere to the printbed. The roll is inside of a plastic shrink wrap sleeve that shrank so tight that the tape roll had actually deformed on the ends, making it tear when taking the tape from the roll. This type of tape is designed to be applied to a wet surface, and squeegeed out, but due to the imperfections in the tape, the water cannot be squeegeed out, and the tape will not stick. It is also quite flamable, it easily caught fire when put near a flame. I am now wondering why it was 74% off... I have a photo of the actual roll of tape, and another photo of a piece pulled off of the roll. It is hard to convey how horrible it is on camera. ABS will not stick to this tape any more than it does a sheet of scanner glass (that's what my heated bed uses) Buy some real Kapton, or lay down some Elmer's Disappearing Purple Glue stick. They will actually work.
Jack Time
Reviewed in the United States on February 2, 2015
good for 3d printing,
Ken S.
Reviewed in the United States on April 10, 2015
It's a descent product if all you want to do is tape flat surfaces. It's so brittle by comparison to others poly tape... it un-sticks itself regularly and refuses to conform to bends and curves.Spend a few $$ more and get the blue-ish stuff... it's more conforming and sticks to almost any prepped surface.
hairu
Reviewed in the United States on November 22, 2014
Worked fantastic for 3D printing. The only problem is that it doesn't fully cover my 6" bed so I have to lay two sheets side by side and that causes a seam in the bottom layer of the print. Get a size to fit your bed exactly if you don't print with a raft.
J. L. Ennis
Reviewed in the United States on October 10, 2014
I use this on my Printrbot 1405 w/ XL upgrade. Really convenient because I only need 1 piece to cover the bed. It also lasts a lot longer than blue tape or kapton.
Recommended Products
$92.43
$ 40 .99 $40.99