Your cart is empty.
Your cart is empty.Product Description
Easier to Remove the Input Shaft Bearing.
Step 1. Use a forceps to remove the outside ring;
Step 2. Make the puller tool cross the transmission shaft;
Step 3. Install the snag rings between notch and top of the puller tool;
Step 4. Use the close ring to cocoon the snag ring;
Step 5. Wring the screw with a ratchet/wrench (Not includes!);
Step 6. Simply Pull out the puller tool until the bearing is loosened.
Package Includes:
Puller Tool
Drive Screw
Snap Ring
Close Ring
Customer
Reviewed in the United States on September 22, 2024
The tool worked until the threads bottomed out without the bearing being fully off. But other than that it worked as it should.
Jacob murphy
Reviewed in the United States on December 14, 2024
The product looked like it was used and resold it was banged up and rusty
Yrc
Reviewed in the United States on September 12, 2023
Muy bueno
Gabriel Taeza
Reviewed in the United States on May 10, 2023
Liked every single piece of it
Goodcoffee
Reviewed in the United States on August 29, 2021
Had to increase stud length using threaded rod for Fro series.
Recommended Products
$23.99
$ 9 .99 $9.99