Your cart is empty.
Your cart is empty.
Inner Diameter: 33mm
Outer Diameter: 46mm
Height: 11mm
Material: NBR (Nitrile)
Dust Seal:
Top Opening ID: 31.5mm (1 1/4")
Bottom Opening ID: 53mm (2.1")
Overall OD: 60mm (2.35")
Overall Height: 31.5mm (1 1/4")
Fits Honda:
CR80R - 1984
CB360K - 1974
CB360G - 1974
CB360T - 1975-1976
CJ360T - 1976-1977
CB400A Hondamatic - 1978
CB400F Super Sport - 1975-1977
CB400T Hawk - 1980-1981
CB400TI Hawk I - 1978-1979
CB400TII Hawk II - 1978-1979
CM400A Hondamatic - 1979-1981
CM400C Custom - 1981
CM400E - 1980-1981
CM400T - 1979-1981
CB450SC Nighthawk - 1982-1986
CB450T Hawk - 1982
CM450A Hondamatic - 1982-1983
CM450C Custom - 1982
CM450E - 1982-1983
CX500 - 1978-1979
CX500C Custom - 1979-1980
CX500D Deluxe - 1979-1981
RBW
Reviewed in the United States on May 9, 2022
The seals are too thick. They do not allow the spacer and retainer to be installed. This also includes the entire Honda 360 line. (CB, CL, and CJ)
Jacob B.
Reviewed in the United States on April 24, 2022
Those seals were so tight going on the stantion. Had to use a flathead to get them on. Two days later, puddle of atf on the floor. Do yourself a favor, source some decent aftermarket seals from a local shop. Or get oem if you can.
Bruce Sayre
Reviewed in the United States on August 26, 2020
Well made and seals the fork tube against leaks.
Jimmy pop
Reviewed in the United States on September 22, 2018
Replace the leaking stock seals on my 75 cb360. Getting the factory seals out was a bear, but the new ones went in easily and no leaks.
Randy Tschiggfrie
Reviewed in the United States on June 17, 2018
Seller was great to work with; I’ve made several purchases from them. That being said, this particular item didn’t work. Seals seemed fine for the first couple of weeks but now one is starting to leak and the other is leaving some oil residue. I’ll continue to buy from 4into1, just not this item.
Recommended Products
