Your cart is empty.
Your cart is empty.Product Description
Marx Milo
Reviewed in the United States on May 19, 2025
These are made of such thin metal that the metal just bends rather then securing the desired object.
S. Blakley
Reviewed in the United States on March 3, 2025
These clamps are built to handle the job without being over-built. The hold the drawer face against the drawer front and keep it in position while drilling holes for screws and handles. These work best on inset drawers, but will work on overlay as long as the top overlay is small enough.I found these easier to use for drawer installation than double sided woodworking tape, as the drawer front is easier to reposition when needed using these clamps. They are also thin enough to fit in the typical gap between drawer faces. This makes it handy to work from the top down when outfitting a cabinet full of inset drawers.The basic process is this...- Use the claps to position the drawer face- Operate the drawer a few times to make sure the setting is correct- Make adjustments and recheck- Drill the necessary holes while the clamps hold the face in position- Screw the face to the drawer box from the inside and add the drawer hardware.- Remove the clamps
Rene R
Reviewed in the United States on March 21, 2025
I ordered these cabinet front panel mounting clamps for another purpose, and they have served well as stop blocks. Attaching a piece of wood to the clamp allowed me to use them as stop blocks on my miter saw and router table fence.
Lilli
Reviewed in the United States on December 12, 2024
Review for Kujunpao C Clamps Large Drawer Front Panel Installation Clamps.These looked like a handy item to have in my woodworking kit-- but after playing with them, I can't quite figure out any real application.The 3 sides of the clamp are built out of a single piece of steel, bent, with small gussets pressed into the corners. The biggest problem is that they're not stout enough to avoid bending the metal ears before adequate clamping pressure is applied to actually do anything. They never really get tight, and the square angle of attack of the pressure screw keeps changing as the metal ears deform. The foam is also too soft to transfer clamping force, since it compresses instead of just protecting against mars. Maybe, just maybe, they could be used to hold an extended drawer panel false front onto a drawer frame that already contained all 5 sides-- but it would be far easier to just use a pair of traditional C-clamps with wood blocks or plastic bumpers (to avoid marring), and you'd have a tool that you could use lots of other places. The hole in the ear behind the screw plate is also badly placed, and too large a diameter to make sense for a temporary locating screw. The maximum clamping width is just over 1.5", the narrow dimension of a 2"x4", by the time you factor in the lost grip range of the interior screw base.My suggestion: skip these, or any similar clamp, and pick any one of the more traditional clamps for your project.
Cody Hirsch
Reviewed in the United States on December 10, 2024
These arrived and I'm happy so far. They are well made and metal so you don't have to worry about them bending or the threads stripping. They arrive pre-assembled and ready to use. I installed some soft protective strips on the clamps to protect woodworking projects and they're even better. I'm very pleased with these for the price.
Recommended Products
$73.51
$ 33 .99 $33.99