Your cart is empty.
Your cart is empty. 100%Brand new & High quality 2 Pin / Way Sealed Waterproof Connector with the 10cm wire Fit: Motorcycle, Scooter, Car, Truck, Quad bike, Trike, Marine, Jet ski, etc. Each set includes: 1 x 2 way Male Connector with 10cm wire Package includes: 5 x Kit 2 Pin Waterproof Connector
Specification: Working voltage: 9 ~ 24VDC
18~20AWG
Ambient temperature: - 40 ℃ ~ + 80 ℃
waterproof level: IP67
Insulator Material: PVC
Mechanical life: 100,000 times
Medium pressure: 550VAC/1S/1mA
Insulation resistance: 10 m Ω, 500 VDC
PHILLIP BOWDEN
Reviewed in Australia on August 30, 2024
Work fine in the application I need it for
MNTom
Reviewed in the United States on July 31, 2022
Have installed and used one at this point. Straightforward install. Worked as expected. Does result in lots of negative wires running to the battery in my case. Would be nice to have a weatherproof cap for female end for when remove the unit wired, e.g., I use one so I can remove my flasher and would like the wiring protected.
PRC
Reviewed in the United States on May 6, 2022
Used these to hook up outdoor rock speakers on the patio. easy to solder into existing outdoor speaker wires. They provide a quick easy connect/ disconnect for the speakers. Just installed, therefore cannot vouch for durability but so far they are good. Will make disconnecting in the fall easy and connecting the following spring a snap.
mick wohllebe
Reviewed in Australia on May 30, 2022
Good quality, as described
Rick America
Reviewed in the United States on May 15, 2022
This is a major quality product it leave no douth once you have them in hand!
Graeme G
Reviewed in Australia on January 29, 2022
Product as described and arrived promptly
Peter
Reviewed in the United States on July 6, 2020
Much better connectors than I expected. Each terminal has a soft silicone seal crimped onto it, and there’s another seal at the connector. The plastic components may actually be AMP brand - mine had an AMP terminal lock on the male connector. For even more sealing, there’s a lip on the wire end of each connector so you can slip some large heat shrink tubing over it. The plastic is soft and pliable so the locking tab is easy to release. The crimps on each terminal look perfect too.
buildpete
Reviewed in the United States on November 5, 2020
I rebuilt a 73 shovelhead and needed dependable connectors and these were what the doctor ordered. Amazing quality as well as secure fitment. I wanted to have ease of use in connecting and disconnecting various items and these were the best find. I highly recommend them and living in Seattle, these see a great deal of moisture and have never leaked.
JCP
Reviewed in the United States on April 2, 2017
These worked great for an LED project on my motorcycle. The wire was of good quality. At first they were a bit difficult to get apart but they get a bit easier to separate and put back together after a few cycles. Can't speak to the waterproof aspect as they are under my seat. I chose waterproof as a just in case.
JP
Reviewed in the United States on August 17, 2016
Good quality connectors for add on to car, allows for disconnection but provides a good water tight seal. I used these to wire in some additional lighting on my truck, this allowed me to build it in with the ability to more easily remove in the future but without worry of weak connection.
gc
Reviewed in the United States on July 14, 2016
The connectors are ok. The first one I used the wire pulled out of the connector while stripping the end. I don't think the ends in the connector are crimped enough. I was careful on the second one and so far it works get. Used it in my boat for my trim tab motor connection in the bilge.
Recommended Products