Your cart is empty.
Your cart is empty.Glass is a universal print surface for 3D Printing. Almost all types of filament will print to glass in one way or another. Just place the glass on your print board and clip it in place! To print with ABS or PLA, lightly spray the surface of the glass with AquaNet hairspray, then install the glass. For Nylon, we’ve found a light coating of UHU Glue stick seems to do the trick! If you don’t yet have a glass surface, you’ll want this one! This glass has been specially ordered and modified for use in 3D Printers. This type of glass is not available at your local hardware store or big box home center. Size: 510mm x 510mm x 4mm, good fit all 3D Printers with 510mm x 510mm or bigger printbed.
John
Reviewed in the United States on March 17, 2025
I purchased this from the GO-3D website in 2021 to keep as a backup but I decided to switch to it after doing some upgrades. On this print, I used alot of hair spray so that PETG will release cleanly since I learned from trial and error that PETG straight on clean glass will pull out chunks of glass.On this GO-3D glass, it's extremely fragile and it shattered the whole thing. It didn't even pull out any chunks, there was no glass stuck to my 3D print so it wasn't because PETG bonds too well to the glass. I've never seen anything like this. $115 trashed after 1 print.I will go back to using 20"x20" mirrors after this experience since it's unknown on the quality of these replacement glass. I've printed 100's of items on this cheap 20x20 mirror. I had no issues with my original Creality glass until I pulled out chunks from printing on clean glass without hair spray and that was a learning experience.
_Set
Reviewed in the United States on May 4, 2023
Large and in charge. It fits another item that is 510mm * 2.
R2D2
Reviewed in Germany on October 18, 2022
Good quality, but had about 5cm corner 0.8 mm lower than the rest.Sadly i broke it, and it's not in stock anymore
Silver Lake
Reviewed in the United States on April 25, 2022
Very disappointed!! Printed one item and the class broke as it was printing. I feel this needs to be replaced as expensive as the item was.
Kindle Customer
Reviewed in the United States on May 29, 2021
For the most part, everything was good. It was packaged well, its glass, and mostly flat. I had one corner that was (in my opinion) out of spec. It was .2mm different but only the last couple inches of a corner. It would only be an issue if I was to print the entire bed size.I would still buy again if I need another.
brian
Reviewed in the United States on November 9, 2019
I dont really have the means to verify its flatness or makeup... but my bed leveler is not exhibiting too much compensation (which I cant say for my original glass). So I am satisfied.It appeared well packaged and arrived in one piece.
Recommended Products
