Your cart is empty.
Your cart is empty. XL-10AH3S wide voltage version, this series of modules can achieve a power on/off function of about 3 seconds by touching the switch, that is, press and hold the button for 3 seconds to turn on, press and hold for 3 seconds to turn off. MAX can support a 10A current load switch, and its power consumption is extremely low in the off state. XL-10AH wide voltage version can support a wide range of voltage from 4.5-26V, and its static power consumption in the off state is about 1.5ua. The excellent performance of the module covers the working voltage and current required by most DC loads. The small size design also does not take up too much space on your device. For the button part, if you want to use other styles of buttons, you can also connect various styles of touch buttons to our switch control board through wires.
Working voltage:
XL-10AH: 4. 5-26V
Static power consumption: (There is a deviation in the sampling test, but it is not significant)
XL-10AH: 1.5ua (12V voltage measurement)
Load current:
XL-10AH: 10A (12V voltage test for 30 minutes)
Pressure drop:
XL-10AH: 120mv (measured at 12V 10A voltage)
matters needing attention
1. Regarding the load current, it is not recommended to run the XL-10AH3S 10A current at voltages below 7V.
2. In the case of low current, the input voltage of the module is basically equal to the output voltage. When the current is 10A, the MAX can reach 170mv, which is difficult to avoid. Therefore, you have to accept this phenomenon.
3. When using the module, do not touch the input and output ports of the module with your hands or other objects with static electricity or low resistance at the same time, as this will cause unstable operation of the module.
Ken J.
Reviewed in the United States on December 5, 2024
For an initial test, I placed this switch module between an LM2596 converter outputting ~4.5V and a noisy hobby motor which drew a bit over 2 amps.After 10 minutes or so, I was surprised to see that even without any heatsinking, the switch's temperature had only risen to ~80°F in a room with an ambient temp of 70°F. To be safe, I would likely add heatsinking for permanent project installation at any higher power level.The 3 second on/off operation functioned as described and was repeatable in my observations.As with most control boards of this variety, input/output grounds are non-isolated.Highly satisfied overall with the value and performance of these switching boards and would order again. 5 stars.
Recommended Products
$48.41
$ 20 .99 $20.99
$55.98
$ 28 .99 $28.99