Your cart is empty.
Your cart is empty.6x6x6mm Tactile push button switch for your electronics projects or to replace a broken switch in an electronic device. Momentary contact, normally open. Through hole mounting with standard pin spacing. These switches work great for Arduino and Raspberry Pi projects.
Rylan
Reviewed in the United States on February 26, 2025
replaced my old gameboy advance shoulder buttons with these, gave a nice solid click. felt a bit different but overall nice
Barry Rogers
Reviewed in the United States on January 14, 2023
These PC board mounted switches saved my big, dead $300 Fellowes 79Ci paper shredder that would not power on. I tore it down, took out the power/forward/reverse switch module, un-soldered old switches, soldered 3 of these in. Perfect fit and function.
joseph soyka
Reviewed in the United States on November 21, 2022
It was exact replacement for old switches
Joel C. Walker
Reviewed in the United States on February 26, 2019
Used to make homemade arcade buttons for a portable gaming system. They work great and haven't had any issues with them at all.
R. K.
Reviewed in the United States on April 1, 2019
Not much to say about these, they just work. Would recommend a different supplier due to cost if you're not in a rush.
Floyd Kennedy Jr
Reviewed in the United States on September 9, 2018
Just the push buttons I needed for my breadboard. Fit perfectly.
Customer
Reviewed in the United States on March 16, 2018
They do not work on proto boards (always pop out). Not recommended for this purpose.
Micah Ting
Reviewed in the United States on January 10, 2017
Works perfectly for my small hobby electronics. It would have been nice if the leads were labeled, but it's easily found with a DMM.
Recommended Products
$5.68
$ 2 .99 $2.99