Your cart is empty.
Your cart is empty.Product Description
DIYmall 7 Bits 7 X WS2812B 5050 RGB LED Ring Lamp Light with Integrated Drivers
Diamter
Diamter: 23mm/0.9''
Back Side
At the back side, it has Data Input, Data Output, GND and PWR +5V
Connection
5V to 5V
GND to GND
Data Input to D6
Code: you can download Neo-Pixel code on github
This RGB LED ring can work with AVR, Arduino, Raspberry Pi, PIC, mbed etc.
Multicolor, bright
You can revise the adafruit code to change the colors, brightness etc.
Very easy to use and great for multiple devices
RGB LED Ring
- Voltage: DC4-7V
- Communication interface: Single-wire communication
- LED Chip: WS2812B
- LED Numbers: 7
7bits + 12bits + 16bits + 24bits WS2812B RGB LED Ring
robert
Reviewed in the United States on March 17, 2025
Bright, easy to use, it's what it says on the tin. Made a little dollar store ghost protector thing a lot cooler
Robert Wagner
Reviewed in the United States on February 25, 2025
Soldering is difficult, but I changed to solder paste and a hot air and I am getting better results. I would give this product more star(s) if there were a data sheet to get the hole placements of the board to aid in designing some special connectors and housing for the light that can be 3D printed.
ctm
Reviewed in the United States on September 10, 2024
Work as advertised. Make a few friendship lamps for the family....fun project!
寺内 敬治
Reviewed in Japan on August 12, 2024
RP20I0でコントロールしました。明るくてスゴくいいです。
Alberto Marun
Reviewed in the United States on July 5, 2024
Estamos hablando que con solo aro con esos 16 led, iluminan de forma excelente, yo lo estoy utilizando en un proyecto con la placa base ESP32 y la compatibilidad es 100%
Rob D
Reviewed in the United States on October 29, 2024
Tested all 5 and they work great! They're all very consistent with one another; none are brighter or dimmer than the others and they're all very bright at full brightness. They seem to have a very sturdy build which I appreciate. I'll be buying more of these in the future when I need more.
Filip To
Reviewed in the United States on April 29, 2024
Not very bright even with all values = 255. It works for my use, nothing to complain.
J. P. T.
Reviewed in the United States on September 5, 2023
Individually addressable, wide color range, bright colors. These are beautiful! Place behind a diffuser (scuffed plastic) for better effect.
Pcfix_3
Reviewed in the United States on July 3, 2023
I'm using an attiny88 to control these for lamps for my grandkids. They are plenty bright and I can control each pixel easily. You might need a 300-400 ohm resistor on the signal wire, but I opted to not do that due to space. I've ran them for a few hours in testing and programming and at full brightness they only got a little warm. I turned down the brightness a bit in the code to hopefully make them last a bit longer.
Recommended Products