Your cart is empty.
Your cart is empty. You will receive:
1pc 70-015-0500 Nozzle Kit.
Fitment:
Fits Models include: KFA210DGD, KFA210TDGD, RMC-KFA210TDGD, RMC-KFA210TL and more.
For Pro Temp, HeatHog, Dayton, WorkHorse, Dyna-Heat, Dyna-Glo, and Dyna-Pro.
Nozzle kit (includes seal, washers, and spring) used on 210-220k BTU oil fired heaters made by Pinnacle and GHP.
Melvin. Braziel
Reviewed in the United States on February 7, 2025
I tried cleaning the old nozzle, but wasn’t successful, AFTER PURCHASING THE NEW NOZZLE MY TORPEDO KEROSENE HEATER WORKED LIKE BRAND NEW
Brett Wexell
Reviewed in the United States on December 9, 2024
This product fixed my Dyna-Glo Model #MHRFA220DGD. The center shaft (where the spring rides) screws into the larger nozzle. At the end of this shaft is a small part (injector?) that I believe mixes air and fuel as it exits the nozzle. The new center shaft was loose on arrival that I tightened, but didn’t check for alignment and probably damaged the new injector. I used old and new parts and made a working unit. Still not sure what was wrong with my old unit. I set the PSI on the compressor to 8.
Steve Grimes
Reviewed in the United States on December 21, 2024
Master torpedo heater
Recommended Products
$113.22
$ 54 .99 $54.99
$22.56
$ 10 .99 $10.99