Your cart is empty.
Your cart is empty.(8) Ford Coil Pack - Allen Socket Cap Head Bolts/Screws & wide Outside Diameter Washers Fits 5.4 and 4.6 V8 Engines – 1992 to 2010 Replaces Ford part #W711062S437 No Rust Ever – Grade 18-8 Stainless Steel Two Different Head Styles available on Amazon Allen Socket Cap Head or Hex Head The factory original equipment coil pack screws were zinc plated common steel fasteners that often rust after a few years. If they seize in place and snap off during spark plug replacement, your problems will begin. Replace them now with Stainless Steel before it is too late Our stainless screws are obviously not exact factory replacements. Actually they are better AND we offer two different head style choices. Our threads are the EXACT size metric threads as the originals and fit perfectly. Our stainless washers have a large outside diameter to help spread the load over the entire area INSTALLATION: You will need a 7 mm socket or wrench to pull the original screws plus an 4 mm Allen wrench or Allen socket to install our new hex screws. NOTE: For added protection, apply a small amount of high-temp anti-seize lubricant to the threads during installation … not included in this pack This packet contains enough hardware to mount eight coil packs. Included are: (8) Metric thread, Allen socket head stainless steel machine screws (bolts) (8) Large outside diameter, stainless steel flat washers
George W.Bergman
Reviewed in the United States on March 12, 2025
Do not buy if the holes are reamed out cause it won't tighten. I had to just barely tighten to get them on. Some are still not tight. But rubber boot is pushed down all the way.
Shepherd's walk
Reviewed in the United States on January 1, 2025
If you have a Ford 5.4 and manage to get the old rusty ignition coil bolts out, have these on hand to go back in and never fight rusty bolts again
Rievalue
Reviewed in the United States on April 27, 2025
Good quality
Wolf
Reviewed in the United States on September 29, 2024
Worked good
michael
Reviewed in the United States on August 5, 2024
Used these Allen socketed bolts on my 5.4 Triton motor, on coil packs 1thru 3 and 5,6 so far easier the regular hex bolts.
mark h. artle
Reviewed in the United States on June 12, 2023
All good, they were the right bolts
Jeremy
Reviewed in the United States on March 7, 2021
Must thread in by hand a good amount because stainless steel it harder than the valve cover material so be careful. Other than that they are great quality and better than stock because they wont rust.
shaylah yother
Reviewed in the United States on November 8, 2019
Would have been nice had it come with the kit we ordered
Recommended Products
$34.85
$ 16 .99 $16.99