Your cart is empty.
Your cart is empty.Product Description
Installation Steps
Installation first step
1. Remove the original gear shifter knob.
2. Remove the aluminum alloy cover from the bottom of the original car shift head
Installation second step
3. Match the size of your gear stick from one of 3 gold rubber adapters, and install on the gear stick.
Installation third step
4. Put into the aluminum alloy bottom cover of the new shift knob into the gear shifter rod.
Installation fourth step
5.Finally the shifter knob is also set on the bar and tightening the aluminum alloy cover.
white shift knob
Adapters size chart
3pcs different adapters of shift gear knob inner diameter are 0.31inch, 0.39inch, 0.47inch (8mm,10mm,12mm), available for your choice.
- Attention: If the three screw sizes are not suitable for your car, I suggest that you can use tape wrapping on your gear stick and then tighten it to solve this problem.
Product parameters and information
Specification:
1.Product name: Ball Shift Knob
2.Material: Resin
3.Color: White
3.Color: Diameter is 2.07nch(52.7mm)
- Attention: 1. If your MANUAL car reverse gear needs to be lifted, then it can't be used
- Attention: 2. If your AUTOMATIC car reverse gear needs button lock, then it can't be used
- Attention: 3. If your original manual gear knob can't be removed, then it can't be used.
- Attention: 4. Before buying, please make sure that the size of the adapter is suitable for your car gear stick size.
- Attention: 6.You can directly view other styles by clicking on the following pictures
J’Shwa
Reviewed in the United States on February 22, 2025
Perfect look for my 02 Jeep Wrangler TJ. The Oder took a while but well worth the wait. I purchased it as an anniversary gift for the day I bought my Jeep.
Marc C.
Reviewed in the United States on February 14, 2025
Works fine on my 2002 Jeep TJ.
Nathan E
Reviewed in the United States on April 15, 2025
Feels sturdy but difficult to get oriented properly AND tight. Once it it tight the orientation is way off, I had used lock-tite to get shifter to show proper position but came loose again after about 2 months.
Recommended Products