Your cart is empty.
Your cart is empty.Product Description
loc nguyen
Reviewed in the United States on January 23, 2025
excellent
James Skiba
Reviewed in Canada on September 18, 2024
Transaction was great but have not had a chance to use it yet
Ben Blass
Reviewed in the United States on July 21, 2024
I should’ve known that nothing universal fits.The first time I attempted to use this it broke pressure around 5PSI and sent brake fluid everywhere.It’s is a poor quality product with an awful design. Find the correct bleeder cover cap for your car and avoid this product.
Manny R.
Reviewed in the United States on March 4, 2024
in most of the brake bleeder kits, not all vehicles are covered. This universal adapter will work on almost every one with a round reservoir. it's pretty much a one size that fits all.
Daniel Poel
Reviewed in the United States on March 21, 2024
Took a couple of tries to get the seal needed but once I got it the brake job was done in a short time
Hayden S
Reviewed in Australia on February 8, 2024
Much cheaper then competitors but the quality is very good, currently using it on Toyota brake systems connected to a Daytona brand pressure fluid bleeder
Ray Breedlove
Reviewed in the United States on April 30, 2024
Very nicely made unit, but even at the tightest it would go, did not hold anything close to the 50PSI (344.7kPa) described. As soon as I went over 20psi, fluid began leaking not only around the master cylinder reservoir opening, but also back up through the center of the Adapter! Quite a mess! If your bleeding requires only low pressure, then this can be a useful Adapter.
Vincent Fuller
Reviewed in the United States on July 6, 2023
It works as described. It was the only tool that I could find that would some what work to bleed brakes alone on a 1973 Land Cruiser
DG
Reviewed in the United States on November 29, 2023
This worked great on my existing Schwaben brake bleeder! This definitely fits a wide range of reservoirs. My only complaint is that when only hand tightening the adapter, it was still difficult to remove by hand and I have to use a small wrench to break it loose. Would recommend this if you work on many different makes of cars.
George Walford
Reviewed in the United States on April 24, 2023
The only way I can see to hook it up to a compressor is to jury-rig something with a hose clamp. Even then I can't be sure it won't pop off.Its a shame, because other than the pressure hook up being this strange connector, the rest of the unit is perfect. Seals all kinds of caps where you might need to pressure them (A gas tank that has been sitting for months to fill the fuel line for example). Fits just fine on Brake master cylinders as well; but good luck coupling it to anything.As it is, I have had to return it because I can't ensure a positive connection to my air compressor.
Recommended Products
$49.99
$ 24 .99 $24.99