Your cart is empty.
Your cart is empty.
Compatible With Dodge
Nitro 2008-2012
Compatible With Jeep
Liberty 2008-2013
Wrangler 2007-2016
Wrangler JK 2018
Joel
Reviewed in the United States on May 16, 2024
This was fairly easy to install and seems to be working well after a week. It is a bit less than the original Mopar sensor. It shipped quickly and saved me $100s in labor.
dm
Reviewed in the United States on March 1, 2024
I had the ABS and Traction Control light pop-on. Jeep immediately started acting like the ABS was engaging at slow speeds, cruise control stopped working. This seemed like the most common solution, so for the price I ordered two. The drivers side rear was awful trying to get the old one out. It was proper stuck. Took at least 1.5-hours to finally get it removed. The passenger rear took, maybe 10-minutes, and it ended up being the passenger side as it was covered in what appeared to be brake dust?So this job could be easy, or not so easy. But this fixed my issue! Both lights went off and the Jeep is back in order.
Eric Bundy
Reviewed in the United States on February 7, 2024
Fixed my engine lights
Linda Fox
Reviewed in the United States on November 18, 2024
Working good
CW
Reviewed in the United States on July 28, 2022
Worked/fit like OEM in my 2016 Jeep Wrangler JKU. Fixed the check engine code. All good!!!
john kovak
Reviewed in the United States on February 24, 2022
Used to replace a bad factory rear ABS sensor on my Wrangler and has held up for 7,500 miles and 6 months so far. well worth the selling price, and i normally only use Oem parts on my jeep but figured this was so cheap worth a try. So far so good.
J40
Reviewed in the United States on April 20, 2022
I have a 2014 Jeep Wrangler Rubicon Unlimited. A few weeks ago, the ABS and Traction Control lights illuminated while I was driving and the speed essentially throttled into a semi limp mode. Afterwards, whenever I started the vehicle, it would feel like a rubbing coming from the back of the Jeep when trying to accelerate. If I powered the accelerator down, it would eventually drive like normal. After reading lots of forums and about to take the Jeep to the shop, I found that the issue could be with the rear wheel speed sensors going bad.In theory, this should be a very quick fix. But the OEM pigtail harnesses on the Jeep have this little red tab that is almost impossible to lift up to remove the pigtail harness from the sensors. You have to use a flathead screwdriver in one hand to press firmly below the red tab and then a pick or another screwdriver in the other to lift up the red tab. Very frustrating but once it is off, you can then take an 8mm socket to remove the bolt that holds the speed sensor in place. Even that is a pretty tight fit.I replaced both rear sensors and took off driving. No issues on the initial acceleration and both dash lights turned off quickly. These sensors were half the price of the auto parts store and I read that taking it to a mechanic would be pretty costly. Took longer than expected because of the harness issue, but only cost me $25 to replace them both. I will update this review if necessary.
cristiansilva3312
Reviewed in the United States on October 22, 2021
Installed on a 2015 jeep wrangler unlimited sport. Traction control and abs lights went on. After replacing this all lights dissappeared. Install was done in under 30min. Perfect fit. Local store priced 2x more for cheapest option. This is a steal.
Recommended Products
