Shopping Cart

Your cart is empty.

Your cart is empty.

ACC Automotive Carpet Compatible with 1965 to 1969 Lincoln Continental, 2 and 4 Door (540-Dark Blue 80/20 Loop)

4.3 (2) Write Review
Free shipping on orders over $29.99

$229.95

$ 95 .99 $95.99

In Stock

1.Color:501-black 80-20 Loop


About this item

  • This item is made in 540-Dark Blue 80/20 Loop carpet. The item image may be a different color, but the SWATCH image is the correct color. Carpet Fits 2 and 4 Door. Unless otherwise noted, the jute padding is heat bonded to the backside of the carpet and a heel pad is welded to the correct location.
  • Holes may not be cut in automotive carpet and carpet may require trimming to install. PLEASE FIND THE INSTALL INSTRUCTIONS ON THE HELP TAB IN OUR STORE DETAILS PAGE.
  • Automotive carpet compatible with Lincoln Continental will be Heat and Pressure formed using a form that was created from the original floor pan. Carpet is guaranteed to fit to the floor when installed correctly.
  • All automotive carpets are Made in USA with Top Quality auto carpet materials. IF YOU ARE NOT 100% SURE OF THE COLOR/MATERIAL YOU NEED, PLEASE CONTACT US BEFORE ORDERING.
  • Automotive carpet will fit just like original carpet when installed correctly and is Guaranteed against Defects. This item fits the years: 1965 1966 1967 1968 1969


  • This automotive carpet will be made in 540-Dark Blue 80/20 Loop. Other colors and materials may be available in the selection above.
  • This carpet is a replacement for 1965 to 1969 Lincoln Continental, 2 and 4 Door. This item does not fit convertibles. Mold Does Not Have Heater Vent Provision That Runs Under Carpet.
  • Carpet will be made with standard flexibe polyethylene backing. Contact us to upgrade to massbacking
  • Unless specified, the jute padding will be attached in the foot area of the carpet
  • Installation may require trimming around the edges and the holes may need to be cut.
  • There is a large variety of colors available. Please request free samples if you want to match a specific color
  • This item fits the years: 1965, 1966, 1967, 1968, 1969, 65, 66, 67, 68, 69

READ FULL INSTRUCTIONS BEFORE BEGINNING - Instructions may vary for multi-piece sets

1. Remove new product from box. Lay flat and pop contours back into place. Allow a few hours for product to relax back into proper shape. Check material for accuracy
2. Compare new and old carpet
3. It may be necessary to use old carpet as a template for console cuts
4. IMPORTANT: Fold new product in half from front to rear. Place in vehicle lining up molded contour to seat risers or any other identifiable starting point. Once fitted, continue installation
5. Roll product forward make cuts for brackets, shifters vents etc while maintaining proper alignment on seat risers or other starting point
6. Cut in center at firewall to allow product to go underneath dash
7. Continue same procedure for remainder of installation – working your way to outer edges
8. Once product is properly fitted you are now ready to do the final trimmings on outer edges, seat belts and holes etc.

Note: If adhesive is desired, only apply a light brush or spray adhesive after correct dry fit has been obtained.


G. Price
Reviewed in the United States on January 24, 2020
First thing first, great carpet- high quality and looks great. The issue I have is that it is so thick that it is difficult to work with. Also, "no need for adhesive" is a bit of a stretch. It fits the general shape but it is not snug in the slightest. It is huge over the transmission tunnel and tight everywhere else. It looks great once everything is in the car but bring the 3M, some and your time.
Terence T.
Reviewed in the United States on December 15, 2019
Excellent quality, fits convertibles although they swear it doesn’t