Your cart is empty.
Your cart is empty.
- This automotive carpet will be made in 521-Dark Saddle 80/20 Loop. Other colors and materials may be available in the selection above.
- This carpet is a replacement for 1967 to 1972 GMC Standard Cab Pickup Truck, 2 WD 4 Speed, Gas Tank Removed. Tunnel measures approximately 6 inches high. Goes to back wall, but not up back wall.
- Carpet will be made with standard flexibe polyethylene backing. Contact us to upgrade to massbacking
- Unless specified, the jute padding will be attached in the foot area of the carpet
- Installation may require trimming around the edges and the holes may need to be cut.
- There is a large variety of colors available. Please request free samples if you want to match a specific color
- This item fits the years: 1967, 1968, 1969, 1970, 1971, 1972, 67, 68, 69, 70, 71, 72
READ FULL INSTRUCTIONS BEFORE BEGINNING - Instructions may vary for multi-piece sets
1. Remove carpet from box. Lay flat and pop contours back into place. Allow a few hours for product to relax back into proper shape. Check material for accuracy
2. Compare new and old carpet
3. Use old carpet as a template for console cuts
4. IMPORTANT: Fold new product in half from front to rear. Place in vehicle lining up molded contour to seat risers or any other identifiable starting point. Once fitted, continue installation
5. Roll product forward make cuts for brackets, shifters vents etc while maintaining proper alignment on seat risers or other starting point
6. Cut in center at firewall to allow product to go underneath dash
7. Continue same procedure for remainder of installation – working your way to outer edges
8. Once product is properly fitted you are now ready to do the final trimmings on outer edges, seat belts and holes etc.
Note: If adhesive is desired, only apply a light brush or spray adhesive after correct dry fit has been obtained.
Stephen Norris
Reviewed in the United States on January 3, 2023
Fits perfect, I have no complaints whatsoever. A little bonus, the bottom is padded/insulated under the driver and passenger foot areas. I did not know that until I opened the box. The carpet quality is very good, so is the driver side rubber pad. Went in my 69 C10
mcconnell
Reviewed in the United States on January 2, 2023
Very poor fit
Justin B.
Reviewed in the United States on December 5, 2021
Will need to cut shifter for 4 wheel drive and for the high/low beam.
Number1
Reviewed in the United States on March 17, 2020
I found this carpet to be everything I wanted, BUT. Well, I didn't know they made/sold GMC trucks that didn't come with carpet. So, when I went to install it, I tried to put the shifter ring in and TOTALLY SNAGGED/RUNNED the fabric to the carper. DO NOT TRY IT. The second time. YES, A SECOND TIME. I tried to remove and cut away where I thought it was a problem. YEEEAAAHHHH, NOPE! Snagged it again. This time a lot worse. Put a run from the front to the back. Going to cover it with the 1967 factory Grandma's House Plastic Floor Runner. :)
Recommended Products
