Shopping Cart

Your cart is empty.

Your cart is empty.

ACC Automotive Carpet Compatible with 2003 to 2008 Toyota Corolla, 4 Door (8295-Medium Doeskin Plush Cut Pile)

Free shipping on orders over $29.99

$197.95

$ 78 .99 $78.99

In Stock

1.Color:801-black Plush Cut Pile


About this item

  • This item is made in 8295-Medium Doeskin Plush Cut Pile carpet. The item image may be a different color, but the SWATCH image is the correct color. Carpet Fits 4 Door. Unless otherwise noted, the jute padding is heat bonded to the backside of the carpet and a heel pad is welded to the correct location.
  • Holes may not be cut in automotive carpet and carpet may require trimming to install. PLEASE FIND THE INSTALL INSTRUCTIONS ON THE HELP TAB IN OUR STORE DETAILS PAGE.
  • Automotive carpet compatible with Toyota Corolla will be Heat and Pressure formed using a form that was created from the original floor pan. Carpet is guaranteed to fit to the floor when installed correctly.
  • All automotive carpets are Made in USA with Top Quality auto carpet materials. IF YOU ARE NOT 100% SURE OF THE COLOR/MATERIAL YOU NEED, PLEASE CONTACT US BEFORE ORDERING.
  • Automotive carpet will fit just like original carpet when installed correctly and is Guaranteed against Defects. This item fits the years: 2003 2004 2005 2006 2007 2008


  • This automotive carpet will be made in 8295-Medium Doeskin Plush Cut Pile. Other colors and materials may be available in the selection above.
  • This automotive carpet is a replacement for 2003 to 2008 Toyota Corolla, 4 Door.
  • Carpet will be made with standard flexibe polyethylene backing. Contact us to upgrade to massbacking
  • Unless specified, the jute padding will be attached in the foot area of the carpet
  • Installation may require trimming around the edges and the holes may need to be cut.
  • There is a large variety of colors available. Please request free samples if you want to match a specific color

READ FULL INSTRUCTIONS BEFORE BEGINNING - Instructions may vary for multi-piece sets

1. Remove new product from box. Lay flat and pop contours back into place. Allow a few hours for product to relax back into proper shape. Check material for accuracy
2. Compare new and old carpet
3. It may be necessary to use old carpet as a template for console cuts
4. IMPORTANT: Fold new product in half from front to rear. Place in vehicle lining up molded contour to seat risers or any other identifiable starting point. Once fitted, continue installation
5. Roll product forward make cuts for brackets, shifters vents etc while maintaining proper alignment on seat risers or other starting point
6. Cut in center at firewall to allow product to go underneath dash
7. Continue same procedure for remainder of installation – working your way to outer edges
8. Once product is properly fitted you are now ready to do the final trimmings on outer edges, seat belts and holes etc.

Note: If adhesive is desired, only apply a light brush or spray adhesive after correct dry fit has been obtained.


Chuck Thompson
Reviewed in the United States on July 7, 2023
Bought replacement carpet for my 2008 Toyota Corolla wshick supplier claied was molded to car pan for a custom fit. It took two people to stretch the carpet to fit, as it was molded only under the front seats !!! This was a blatant misrepresentation of the product. What other specific faults will I find as time goes on ?
CMA Major Rocketman
Reviewed in the United States on May 29, 2019
carpet is close to original although many of the mounting holes and are not there and some of the shapes just don't match.. requires a bit of cutting and adjusting... some spray glue to hold it down in places but in the end it looks good if not a completely perfect fit