Your cart is empty.
Your cart is empty.Product Description
Product dimensions (dimensions in millimeters and inch):
Featured Accusize Tools annular cutters
13 Pcs/Set 7/16" to 1-1/16" HSS Annular Cutters, 2" Cutting Depth with 2 Pilot Pins in Strong Plastic Box
- Cutting Depth: 2''
- Cuts holes in steel accurately, quickly & safely
- Large holes can be drilled up to ten times faster than regular drills bits
- Make overlapping holes, slotting holes and edge cuts
- Made from tough, high-speed tool steel
- Machine-finish hole-no reaming needed when used with lubricant
- with 3/4'' Weldon shank
- Seller SKU: N2
Dia of Cut: 2-1/2 in, 1-1/4 in. Weldon Shank, H.S.S. Annular Cutters, with 1" Cutting Depth, ANSI Standard, Weldon Shank, CBN Ground
- Make overlapping holes, slotting holes and edge cuts
- Eliminates Multi-Step Drilling
- Lower Cost per Hole
- Premium High-Speed Steel
- With 1-1/4'' Weldon Shank, Hole of Pilot Pin = Dia.5/16''
- Seller SKU: 2080-2045
H.S.S. Annular Cutter Set - 1" Cutting Depth, 7/16" - 1-1/16'', 8 Pcs/Set
- Cutting Depth: 1''
- Cuts holes in steel accurately, quickly & safely
- Large holes can be drilled up to ten times faster than regular drills bits
- Make overlapping holes, slotting holes and edge cuts
- Made from tough, high-speed tool steel
- Machine-finish hole-no reaming needed when used with lubricant
- with 3/4'' Weldon Shank
- Seller SKU: HSS1-0000
MB
Reviewed in the United States on February 4, 2022
I have bought some Accusize in the past. I've also been reading some of reviews recommending against the brand. My turn. The run out is large. I don't have a figure, one can see it. It makes my entire drill flex and squirm. Unfortunately, I have to use it, time is up on the project. I am concerned it could hurt my drill. Looks like I'm going back to name brand tools.
Crazygroup41
Reviewed in the United States on May 27, 2019
I haven't used it, but looks nice.
murfonline
Reviewed in the United States on December 13, 2017
Works really well. Note This is not something you put in your drill chuck and chuck it in like a drill bit. You remove your chuck and this slides in replacing your chuck on your drill.Once installed the item works really well.Most drill presses have a slot (visible when you pull the handle part way down) you put a tapered key (file handle is tapered) into the slot and tap with hammer. Your drill chuck will fall out and put this one in.
Shopman
Reviewed in the United States on April 18, 2017
perfect for adaptation on milling machine or large drill press
B. WANZEK
Reviewed in the United States on June 5, 2015
This shank is very well built and will last a long time. Tops in my tool box.
Recommended Products
$32.99
$ 13 .99 $13.99
$48.99
$ 22 .99 $22.99
$32.89
$ 16 .99 $16.99