Your cart is empty.
Your cart is empty.ACDelco GM Original Equipment Automatic Transmission Dipstick Tube is a GM-recommended replacement component for one or more of the following vehicle systems: automatic transmission/transaxle, and/or manual drivetrain and axles. This original equipment tube will provide the same performance, durability, and service life you expect from General Motors.
Angie Ritch
Reviewed in the United States on July 18, 2024
Oil change place refused to check my transmission fluid. I tried JB welding and electric tape....that was my mechanical ability. That was until a coworker said just buy a new one it will come with the clip that's broken. So it did. Installing was nothing. Fit perfect. I can't believe I fought with that stupid stick for over a year. Thanks for selling on Amazon!
ALEJANDRO H.
Reviewed in the United States on June 27, 2024
Fitted perfectly on 05 CANYON.
david munguia
Reviewed in the United States on May 5, 2024
Is very good quality and exact part fits like a glove
Yuliana Resendiz
Reviewed in the United States on October 20, 2024
Helped fix the leaking in my 06 Chevy Colorado. Haven’t had any issues so far and quality feels good.
Garrison
Reviewed in the United States on August 24, 2023
probably works for what it was meant for, this will not work or fit on a c10 though with 700r4 swap.
tom la france
Reviewed in the United States on July 14, 2023
Ordered on Friday—arrived SUNDAY! How does it get to a remote Oregon location—so fast! THESE ARE EXTREMELY EASY TO INSTALL. sorry stuck on caps. Just order the new seal with it, and clean and use Vaseline to insert new one. Remove and replace a 10mm nut. THAT easy! Works perfect. Shiny and new.
Rafael
Reviewed in the United States on February 2, 2020
I accidentally broken the tube on my truck doing some maintenance and picked this one up to replace it. It was a perfect fit on my 2006 Hummer H3. All you have to do is remove the nut holding the tube to the engine block and pull this tube right up. It simply slides in and out of the rubber washer down in the tranny fluid reservoir. You pull this one up and slide the new on in then attach the nut and tube back to the engine block. There was no fluid spilling for me at all so did not have to replace it. I also picked up the rubber washer just in case but it looks like the old is still ok so I did not replace it.
Kenneth W. Miller Sr.
Reviewed in the United States on April 28, 2018
They all were fine.
Recommended Products
